2.
■ Important-Safety Precautions This device of which operation is subject to the following two condition (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. • To prevent fire or shock hazard, do not expose this device to rain or moisture. Do not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool.
B. Introduction to 2.4GHz Wireless AV Link This sender system is a wireless audio/video sender that uses advanced wireless communication technology to deliver consistently sharp audio and video up to 100 meters away. By transmitting at a very high frequency (2.4 GHz), it avoids the crowded 900 MHz band used by many cordless telephones and other wireless audio/video transmitters. It’s superior quality is due to wide-band FM rather than AM signal modulation.
REAR VIEW FOR TRANSMITTER C. Product Layout The following illustrations show the names of each component, button and switch connectors on the transmitter and receiver. Power on/off switch Channel Switch FRONT VIEW FOR RECEIVER MINI DIN AV Jack DC power input, connect to power adapter (9VDC) LED Channel REAR VIEW FOR RECEIVER CH4 (NTSC only) RF output to TV (e.g.
D. Setting Up 2.4GHz wireless AV Link To enjoy wireless video and audio, just connect the transmitter to whatever audio/video source you want to enjoy from another location, and connect the receiver to the TV, monitor or powered speakers in that other location. Make sure the ON/OFF switch is in the cOFF f position before connection.
■ How To Transmit Audio/Video from Your VCR 1. Connect VCR and transmitter using the provided “MINI DIN TO SCART A/V CABLE” with green MINI DIN plug, plug SCART to VCR output jack, MINI DIN to transmitter. Please follow the instruction figure below. 2. Plug one end of the power adapter into the back of the transmitter and the other end into any 230-volt wall outlet (or 120-volt), Use only the adapter provided. 3. If you VCR has only one set of A/V output jacks and you want to use it with a nearby TV.
■ How To Receive Wireless Audio/Video Signals on Your TV There are two ways to receiver wireless audio/video signals on your remote TV (TV in another location such as in bedroom, kitchen). · Connect the receiver directly to the remote TV. · Connect the receiver to a VCR, which is then connected to the TV.
E. Orienting Units for Optimum Performance This sender system should be placed on a flat, stable surface to prevent damage to it from falling. For optimum performance, both the audio/video and remote control antennas should be carefully oriented as described below.
G. Troubleshooting, Care and maintenance Please read this owner's manual carefully and follow the steps described in it. If you still have difficulties, consult the following table. It will guide you though the most common problems and their solutions. Problem No picture or sound Interference: Noisy picture or audio Remote control extender does not work Possible solutions • Check all cable connections. • Make sure power plugs are pushed all the way in.
