Important — Safety Precautions 1. To prevent fire or shock hazard, do not expose this device to rain or moisture. 2. Do not use this video device near water. For example, a bathtub, watch bowl, kitchen sink, laundry tub or swimming pool, or in a wet basement. 3. No naked flame sources, such as lighted candles, should be placed on this device. 4. To avoid electrical shock, do not open this device, and do not insert any metallic object through the ventilation grills, S.
1.2 Select the channel on the monitor by setting the dip switch to the ON position. The dip switches are numbered 1 to 4 are for channel setting. The T dip switch sets the timer for the auto-sequence function . See Fig CH CH2 CH3 CH Channel Selection Switches Screw for Fixing Angle 3. Microphone 4. Lens 5. Infrared LED (provide infrared light for night vision) 6. Mounting bracket TT Setting UP 12347 1 Select Channels The camera and monitor MUST BE set at the same charmer. 1.
2 Setting up the monitor 2.1 Power supply The monitor uses either or household AC current. To load batteries 1. Open the batteries compartment cover in the direction of the arrow. 2. Insert batteries so their plus(+) and minus(-) ends are facing as shown in Fig? 3. Close the batteries compartment cover. Make sure the battery compartment cover is locked securely. Note: Never mix old batteries with new ones. Remove batteries from the monitor if you do not plan to use it for a period of time, 4.
3.1 Fine Tuning 1. Adjust the camera’s viewing angle by muting its body. 2. Loosen the screw on the bottom of bracket and rotate the camera to make adjustments. 3. When satisfied with the picture coverage, re tighten the screw. Note: After adjusting the viewing angle, make sure the camera body is attached to the pivot of the bracket tightly. Other Applications Recording on a VCR ‘The monitor comes with AV (audio/video) output jacks for connecting to a VCR for recording. See Field.
Note: When none of the dip switches are in the ON position, the monitor will automatically set the receiving channel to channel 1. Example: If you have two wireless cameras and their channels are set on CHANNEL 1 and CHANNEL 3, and you wish to monitor the two channels in sequence, you must slide up the first and third dip switches to the ON position(see the diagram below). If you wish those two channels to be alternated at eight-second intervals, slide the T dip switch to the ON position.
Monitor © ONO Aw Receiver Frequency: 24/4 IZHEVSK& HE (4 channels ) Receiver sensitivity: -80dB8m Channel design: PLL frequency synthesizes Modulation: FM Antenna: built-in directional antenna Display: 5.5” BW monitor Resolution: 320 TV lines AV output port: RCA Power supply(optional): 12VDC, 1200mA or 10 C-size batteries . Dimension: 200mm*155mm* 165mm .