Chapter Table of Contents Page 1 Breadth first. Conn 2 2. The 2.4GHz Wireless Color Camera Kit..oiimiimiimii 38 3. Installation of the system... 810 4. Trouble Technical specifications... 12 1. Important-Safety Precautions This device of which operation i subject to the following two conditions: 1: This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may valise aniseed ops cation.
2. The 2.
Channel Selection SW 2-3. Control Element, Receiver Front View of Receiver Rear View of Receiver 1. AV output cable with RCA or SCARY 2.0 BLOC power adapter lack 3. AV output MINDING lack 4. Channel selection DIP SW (as shown in Figs) Select the channel by setting the channel DIP. SW to the ON position 1234 oN . ou Sigh CHANNEL SELECT DIF aw DIR BW Function: DIF SWED-4: set one channel or multi-channel sequence function.
B. Fix's one channel Mode: 1234 1234 G00 mu or MMM or HNN Fig 1 Fig 2 Fig 1: Channel 1 1s selected. BLUE LED located on front of the Receiver will blink once at intervals of 4 seconds. Fig 2: Channel 3 is selected. BLUE LED will blink 3 times at Intervals of 4 seconds. C. Automatic channel sequence mode. Figs Fig 3: Channel 1 and channel 2 are selected in sequence. BLUE LED will blink once and 3 Hines in calico sequence at intervals 4 second.
3-2 Transmitter AVDP 160mA AC Adapter (Camera) or SVN Battery Cover Replace the cover AN Output Cable (Camera) as necessary GV Cuisinart) AL Adapter Supplied j TVs AV coupon cable ROA socket of the TV sel input port note; switch the TV seat : AV Gr Video-input) 3-3 Receiver STATIC 300mA AC Adapter (Receiver) AN Output Cables (Receiver) AV pulpit Cable To the RUA socket {note switch the TW satin AY provide-input} SVBCE0mA AL Adapter Supplied
4. Trouble —shooting 1. No image or sound a Make sure the prows supply switches on the hack of the receiver and an the top of the transmitter are in the ON’ position. bf this SVN Battery power 1s in low power condition, can changing the new SOC Battery. © Check comet position of all the connectors and plugs. d Make sure the transmitter and the receiver are On the same channel. 2. Interruptions in image and sound 2. Make sure position of the transmitter and the receiver are in comet alignment. b.