oii [2063 > fee Io. NOQ IH 2043s 20b2/2064 > Fee 2p: NORRIS 20040 MAJESTY 2.4GHz WIRELESS AV LINK OWNER’S MANUAL (PLEASE READ BEFORE USE) sd 8 2061/2062 without remote control extender 2063/2064 with remote control extender (TRANSMITTER RECEIVER:2062) MAJESTY ELECTRONICS CO., LTD FCC ID Model | 24 GHz TX | 24 GHz RX 418 MHz 418 MHz AVID .
A. Specifications Transmitter: 2061/2063 Output Level Operating Frequency Band Modulation Video Input level Audio Input Level Video Input Impedance Audio Input Impedance Power consumption Dimension Weight Receiver: 2062/2064 Output Level Noise Figure Power Consumption Remote Control Transmitter Frequency RF Output Channel Dimension Weight 90 dBuv/m at 3 meters 2.4102.4835 GHz FM (video and audio) IVpp@1750Q IV p-p @ 6000 75 Q 600 Q 12VDC, 350mA 18cm X 12cm X Sem 400g I VP-p (video), 1 VP-p (audio) 3.
B. Checking Contents of Box Check to make sure that all of the items shown as below ar 2.4 GHz Wireless Video Sender System. If something contact your dealer as soon as possible. 2063 with Remote R . Power adapters (230VAC and 4. TV hook-up cable, ® . 9.5mm plug to 9.5mm jac 1 5. Cable adapter, F plug one for receiver fy 7. Audio/Video RCA cable 8. IR extender to connect to © & transmitter’s rear panel 9. Fasten strips 10. Owner's manual as 6.
BM Important-Safety Precautions = To prevent fire or shock hazard. do not expose this product to rain or moisture. Do not use near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool. » To avoid electrical shock, do not open this product. * This product should be operated to use only the power supply included with it or provided as an accessory. * Do not overload wall outlets and extension cords as this can result in the risk of fire or electrical shock.
C. Introduction to 2.4GHz Wireless AY Link This sender system is a wireless audio/video sender that uses advanced wireless communication technology to deliver consistently sharp audio and video up to 100 meters away. By transmitting at a very high frequency (2.4 GHz), it avoids the crowded 900 MHz band used by many cordless telephones and other wireless audio/video transmitters. It’s superior quality is due to wide-band FM rather than AM signal modulation.
D. 2061/2062 Panel Controls and Features The following illustrations show the names of each components, button and switch connectors on the transmitter and receiver.
Feces: vOQ am aortas REAR VIEW FOR TRANSMITTER (2061) Power on/off switch DC power output port (12V, 100mA max.) {make sure the ON/OFF switch is locate the” OFF position before use) Audio Left (white) in Audio Right (red) in Video Jack (yellow) in DC power input, connect to power adapters (12V) Fee zp: Moscow aon REAR VIEW FOR RECEIVER (2062) Power on/off switch Channel select CH3 or CH4 (SCENT only) RF output power output port (12V, 50mA max.
E. 2063/2064 Panel Controls and Features The following illustrations show the names of each component, button and switch connectors on the transmitter and receiver. FRONT VIEW FOR TRANSMITTER AND RECEIVER UHF antenna sends and Directional 2.
REAR VIEW FOR TRANSMITTER (2063) IR extender output port Power on/off switch DC power output port (12V, 100mA max.) for approved accessory Audio Left (white) in Audio Right (red) in DC power input, connect to power adaptation) Video Jack (yellow) in REAR VIEW FOR RECEIVER (2064) power on/off switch Channel select CH3 or CH4 (SCENT only) RF output to TV DC power output port (12V, 50mA max.
F. Setting Up 2.4GHz wireless AV Link To enjoy wireless video and audio, just connect the transmitter (Model 20610r 2063) to whatever audio/video source you want to enjoy from another location, and connect the receiver (2062 or 2064) to the TV, monitor or powered speakers in that other location. ROOM 1 ROOM 2 SAT Receiver \ Receiver TV Set VCR Transmission ») (Camera) Camcorder Fos Moss sass, 2068201 os 208101 2063 Transmitter Fee To Moog aol 3s reeve. Vortex assets Ult-Media PC Controller and more...
Make sure the ON/OFF switch is in the! OFF ERC GLUE MW How To Transmit Audio/Video from Your VCR 1. Connect one set of audio/video (A/V) cables (or scary cable labeled "Sender™) to the A/V jacks of the transmitter (2061 or 2063) and to the A/V output jacks (or scary connector) on the back of your VCR. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the VCR and the transmitter.
WM How To Transmit Audio/Video from Your Satellite Receiver You can transmit audio/video either directly from your satellite receiver, or by connecting them to your VCR. To transmit directly from your satellite receiver, follow the instructions below. 1. Connect one set of audio/video (A/V) cables (or scary cable labeled "Sender") to the A/V jacks of the transmitter (2061 or2063) and to the AUDIO/VIDEO out jacks (or scary connector)of the satellite receiver or laser disc player.
HB How To Receive Wireless Audio/Video on Your TV There are two ways to receiver wireless audio/video signals on your remote TV (TV in another location such as in bedroom, kitchen). + Connect the receiver directly to the remote TV. Connect the receiver to a VCR, which is then connected to the TV.
HM Connecting Receiver to Remote TV through VCR 1. This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the picture and sound on a remote TV at the same time. Connect one set of audio/video (A/V) cables to the A/V output jacks of the receiver (2062 or 2064) and to the A/V input jacks on your VCR. Be sure the yellow, red and white plugs match the yellow, red and white jacks on both the receiver and the VCR.
G. Orienting Units for Optimum Performance damage to it For Optimum performance, both the audio/video and remote control antennas should be carefully oriented as described below. In addition, to use the remote extension feature (available with 2063 and 2064 only), the transmitter itself must be specially oriented so it can-relay the converted remote control signal back to the audio/video source (see following section titled "Using The Remote ~ Control extension Feature”).
REMOTE CONTROL ANTENNA (2063 ONLY) ANTENNA PITTED REMOTE ANTENNA “a sie CONTROL PITTED ~, ANTENNA SIDE (2063 ONLY) ANTENNA PITTED a SIDE ed pr TRANSMITTER “REMOTE (From View} CONTROL ANTENNA receiver REMOTE (2084 ONLY) (Freon( View) CONTROL ANTENNA (2064 ONLY) RECEIVER TRANSMITTER (Frau View) (Front View) Fig-2 Fig-3 Orienting the Remote Control Antennas (2063 and 2064 only) In order to obtain optimum performance of the remote control extender, the remote control extender, the remote control antennas should
H.
Please read this owner's manual cared I. Troubleshooting , Care and maintenance sully and follow the steps described in it. If you still have difficulties, consult the following table. It will guide you though the most common problems and their solutions, Problem Possible solution ] — Neo picture or sound * Check all cable connections, * Make sure power plugs are pushed all the way in. * Check power switches on the remote TV and video source. ( VCR, laser disc player, satellite receiver, ect.