User's Manual

Model No. : 3568BRF

2.4GHz Digital RF Transceiver Module

1. Description:

3568BRF is highly integrated 2.4GHz ISM Band RF

Transceiver with embedded Power Amplifier, LNA,

PLL, AGC, Modem, and used Adaptive Frequency Hopping to avoid the

interference from ISM BAND.This module has high transmission data rate; low

current consumption and simple control interface is easy to apply to the

wireless products.

2. Specification:

- Frequency band : 2400~2483.5 MHz

- Digital Modulation: Support BPSK/QPSK/16QAM

- Operation Voltage: 2.7V~3.3V

- Output Power : 15.5 dBm

- Sensitivity: -88dBm

- Data Rate: Up to 12 Mbps

- TDD full-duplex, including decoder, encoder and 1000 byte FIFO data buffer.

- Supports Auto ACK and & Retransmit

- Supports CRC.

- 4-wire digital interface (SPI)

3. Application:

- Wireless mouse, keyboard, joystick

- Keyless entry

- Alarm and security system

- Home automation

- Surveillance

- Automotive

- Telemetry

- Industrial sensors

- Wireless data communication

PAGE 1
Model No. : 3568BRF 2.4GHz Digital RF Transceiver Module 1. Description: 3568BRF is highly integrated 2.4GHz ISM Band RF Transceiver with embedded Power Amplifier, LNA, PLL, AGC, Modem, and used Adaptive Frequency Hopping to avoid the interference from ISM BAND.This module has high transmission data rate; low current consumption and simple control interface is easy to apply to the wireless products. 2. Specification: - Frequency band : 2400~2483.
PAGE 2
4. Pins Assignmemt GND Connect 2.4G Antenna signal GND Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 Pin 9 Pin 10 Pin 1: Power supply voltage +5V. Pin 2: Ground connection. Pin 3: 12MHz clock output. Pin 4: Interrupt indication for external MCU. Pin 5: Chip selection for SPI interface. Pin 6: Data output for SPI interface. Pin 7: Data input or 3-wire data output. Pin 8: Clock input for SPI interface. Pin 9: Ground connection. Pin 10: 32kHz crystal output. 5.
PAGE 3
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Label for end product must include “Contains FCC ID: NOQ3568BRF” or “A RF transmitter inside, FCC ID: NOQ3568BRF”. FCC ID Label Graph: Type: 3568BRF FCC ID: NOQ3568BRF This device complies with Part 15 of the FCC Rules.