Installation & Assembly

INSTALLATION INSTRUCTIONS
ATTACHING LOW VOLTAGE H2 FIXTURE TO TRACK SYSTEM
Technical Support
855-592-0029
[e-mail]
www.jescolighting.com
Instruction sheet subject to
change without prior notice
1/7/2016
Page 1
Read and understand these instructions before installation
This product is intended for installation in accordance with the National Electric Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before installation.
To prevent electrical shock, turn off electricity at fuse box before proceeding.
No consumer serviceable parts. Contact factory if service is required.
For use in dry locations only.
Retain these instructions for maintenance reference.
P1 = Lowered position. Single circuit track or circuit
#1 of two circuit track. (Factory setting)
P2 = Raised position. Circuit #2 of two circuit track.
Identifying Polarity
Note the polarity line when installed.
CAUTION
RISK OF ELECTRICAL SHOCK
DAMAGE TO TRACK AND ADAPTOR IF ORIENTATION IS INCORRECT