Quick Start Manual

ManualsBrandsJensen ManualsAudioJensen VM9125

VM9125

What’s in the Box

VM9125 Head Unit

Left and Right Double DIN

Mounting Brackets

Double DIN Half Sleeve Install

Bracket

Two Custom Cosmetic Trim Rings

Parking Brake Wire

Hardware Bag

Speaker Output Harness

Power Input Harness

Accessory Harness

Installation Guide

Tools and Supplies

You will need these tools and supplies

to install your VM9125:

• Torx type, at-head and Philips

screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screw

driver, socket wrench set or other

tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

WARNING! Never install this unit where operation and viewing could interfere with

safe driving conditions.

Summary of content (4 pages)

PAGE 1
VM9125 What’s in the Box VM9125 Head Unit Left and Right Double DIN Mounting Brackets Double DIN Half Sleeve Install Bracket Two Custom Cosmetic Trim Rings Parking Brake Wire Hardware Bag Speaker Output Harness Power Input Harness Accessory Harness Installation Guide Tools and Supplies You will need these tools and supplies to install your VM9125: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screw driver, socket wrench set or other tool
PAGE 2
Optional Equipment • Rear Camera Disconnecting the Battery • T o prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9125 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.
PAGE 3
Installation Using Half-Sleeve 1. Install half-sleeve in the dashboard. a. Install adapter if necessary (optional). b. Install half-sleeve into adapter or dashboard (use only the supplied screws). Do not force the sleeve into the opening or cause it to bend or bow. WARNING! Only connect the unit to a 12-volt power supply with proper grounding. c. Locate the series of bend-tabs along the top, bottom and sides of the mounting sleeve.
PAGE 4
Wiring Diagram Wiring Diagram CAUTION! IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, CAUTION! IMPORTANT: Incorrect connectionstechnician. can damage the unit. Follow the wiring instructions carefully, or have the installation handledwiring by an experienced or have the installation handled by an experienced technician. Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.