Quick Start Manual

ManualsBrandsJensen ManualsAudioJensen VM9116

VM9116

VM9116 Head Unit

Single DIN Sleeve

Wiring Harness

Mounting Hardware

Cosmetic Trim Ring

Owner’s Manual

Installation Guide

Tools and Supplies

You will need these tools and supplies to install your VM9116:

• Torx type, at-head and Philips screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screwdriver, socket wrench set or other tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

What’s in the Box

WARNING! Never install this unit where operation and viewing could interfere

with safe driving conditions.

Installation Guide

Summary of content (4 pages)

PAGE 1
Installation Guide VM9116 What’s in the Box VM9116 Head Unit Single DIN Sleeve Wiring Harness Mounting Hardware Cosmetic Trim Ring Owner’s Manual Installation Guide Tools and Supplies You will need these tools and supplies to install your VM9116: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screwdriver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for powe
PAGE 2
VM9116 Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9116 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit. Pre-installation 1.
PAGE 3
VM9116 Wiring WARNING! Only connect the unit to a 12-volt power supply with proper grounding. Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the battery negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch. NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the radio.
PAGE 4
VM9116 Wiring Diagram IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician. BLUE SUBWOOFER REAR R RED REAR L WHITE PRK SW PARKING BRAKE PINK CAMERA IN YELLOW VIDEO OUT YELLOW External Power Ampliﬁer Antenna Jack Antenna Harness Cord BLUE Auto antenna control (connect to antenna control lead & power supply of antenna ampliﬁer) ANT.