Installation Instructions

ManualsBrandsJELD-WEN ManualsDoorsBuilders Series 81" Wide x 50" High Single Hung Vinyl Bay Window with Colonial Grids - White/White

for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025)

Thank you for selecting JELD-WEN products. Attached are JELD-WEN’s

recommended installation instructions for Vinyl Bay/Bow windows

with an integral nail n. Not all window types may be installed into

every wall condition in all areas. Consult your local building code

ofcial for applicable building codes and regulations. Local building

code requirements supersede recommended installation instructions.

Areas such as Florida and the Texas TDI region have different anchoring

requirements based on product certication. For information on

specic products, visit www.oridabuilding.org or www.tdi.texas.gov

and follow the anchoring schedule given in the drawings for the

product instead of the anchoring schedule in this document.

Bay Bow

Summary of content (6 pages)

PAGE 1
Installation Instructions for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025) Thank you for selecting JELD-WEN products. Attached are JELD-WEN’s recommended installation instructions for Vinyl Bay/Bow windows with an integral nail fin. Not all window types may be installed into every wall condition in all areas. Consult your local building code official for applicable building codes and regulations. Local building code requirements supersede recommended installation instructions.
PAGE 2
Installation Instructions for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025) IMPORTANT INFORMATION | TABLE OF CONTENTS | GLOSSARY PLEASE NOTE: Installations where the sill is higher than 35 feet above ground level, or any product installation into a wall condition not specifically addressed in these instructions, must be designed by an architect or structural engineer.
PAGE 3
Installation Instructions for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025) MATERIALS AND TOOLS Needed Materials NOTE: JELD-WEN exterior window and door products should be installed in accordance with JELD-WEN’s recommended installation instructions, which are printed on the product label or can be found on our website: www.jeld-wen.com.
PAGE 4
Installation Instructions for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025) 2 INSPECT ROUGH OPENING (R.O.) • Verify the width and height of the rough opening is 1/2"- 5/8" larger than the window width and height. • Verify the rough opening Verify Square, Level and Plumb is square. The (A) and (B) measurements should be the same. Suggested deviation from square is no more A than 1/4". • Verify the rough opening is E C level and plumb (C, D and E).
PAGE 5
Installation Instructions for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025) 4 TEMPORARILY FASTEN AND SHIM PRODUCT WARNING! To avoid injury, use at least two people to install. Adequately support the window until completely fastened. 1. Fastener locations 1 1/2" around the interior perimeter should be pre-drilled and countersunk prior to setting the window into the opening. 4" • Pilot holes should be located 1 1/2" from the interior edge.
PAGE 6
Installation Instructions for Vinyl Bay/Bow Windows with Integral Nailing Fin (JII-90025) 6 INSTALL DRIP CAP The use of a drip cap on all window/door products is recommended, regardless if supplied. A drip cap is required on any vertical mulled/joined products, regardless if supplied. NOTE: A drip cap may not be suitable for some product lines (e.g. brickmould vinyl, flush fin, vinyl flat casing), regardless these product lines need to be incorporated into the wall in a weather-shedding manner.