User's Manual

ManualsBrandsJDTECK ManualsElectronicsEXTERNAL RADIO FREQUENCY POWER AMPLIFIER

Table Of Contents

Specifications:

Signal Booster User’s Manual

Models: CB-819 / CB-918 / CB-806

CB-819

CB-918

CB-806

Model

Uplink (Mhz)

Downlink (Mhz)

825-845

870-890

1850-1910

1930-1990

890-915

935-960

1710-1755

1805-1850

805-821

850-866

Output Power (dBm)

Uplink / Downlink

33/0 (Typ)

30/0 (Min)

33/0 (Typ)

30/0 (Min

33/0 (Typ)

30/0 (Min

33/0 (Typ)

30/0 (Min

33/0 (Typ)

30/0 (Min

33/0 (Typ)

30/0 (Min

Min. Gain (dB)

Uplink / Downlink

15 / 15

Power Consumption

DC 12V / 2A

Connector

SMA - Female

Weight

250g

Dimensions

100 x 75 x 25mm

Version 1.0

Summary of content (4 pages)

PAGE 1
Specifications: Signal Booster User’s Manual Models: CB-819 / CB-918 / CB-806 Model CB-819 CB-918 CB-806 Uplink (Mhz) 825-845 1850-1910 890-915 1710-1755 805-821 Downlink (Mhz) 870-890 1930-1990 935-960 1805-1850 850-866 Output Power (dBm) 33/0 (Typ) 33/0 (Typ) 33/0 (Typ) 33/0 (Typ) 33/0 (Typ) 33/0 (Typ) Uplink / Downlink 30/0 (Min) 30/0 (Min 30/0 (Min 30/0 (Min 30/0 (Min 30/0 (Min Min.
PAGE 2
Table of Contents FCC Statement • Introduction ……………………………………………………… 3 PLEASE NOTE: It is normal for your booster to be quite warm while in use. • Installation Procedures…………………………………………. 4 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in • Troubleshooting………………………………………………….6 a residential installation.
PAGE 3
Installation Procedures – Cont’ Introduction Indoor Setup The JDTECK Signal Booster is ideal for use in motor vehicles, boats, home or office use, where there may be a weak signal in the cellular network. This poor 1. Decide on a suitable place for installing reception may be the result of distance from the nearest cell tower or the the booster. It is advisable to have as close presence of obstructions between the cell tower the receiving device. as possible to the mobile phone. 2.
PAGE 4
Installation Procedures Installation Procedures – Cont’ In vehicle Setup (Direct Connect) In vehicle Setup (Hands Free Kit) A. Firstly install your antenna. (1) A. Firstly install your antenna and HFK. B. Route the cable to inside the vehicle and B. Route the cable to inside the vehicle and connect to the booster (3) socket connect to the booster (3) socket marked marked “antenna”. “antenna”. C. Connect the HFK cable (1) to the booster C.