User's Manual

ManualsBrandsJCM Technologies ManualsElectronicsTransceiver for Automatic Door Safety Edges

1248xxx_Rev0.0 RB3 OSE916 Page 1/4

RB3 OSE916

User’s Manual EN

Introduction

The RadioBand system is designed for Commercial and Domestic door applications where a safety edge is used. The system provides

a wireless system replacing spiral cables or energy chain systems to provide the safety signal to the door or gate control panel. The

receiver monitors the status of transmitters connected to it. When an obstacle is detected, the RadioBand system puts its output in a

safety state.

Up to three transmitters per output can be connected to the receiver. There are two outputs on each receiver that can be connected to

the control panel, one as OSE interface, and the second one is a normally close contact.

The system complies with EN ISO 13849-1:2008, category 2, PLd.

The manufacturer reserves the right to change the specification of the equipment without prior warning.

Technical data

Frequency

Multifrequency system 916 MHz auto-adjustable

Memory

6 transmitters (3 on output 1, 3 on output 2)

Power supply

12/24V ac/dc

Power supply range

9-35V dc

8-28V ac

Consumption standby/operating

Max 255mA

Radiated power

< 25mW

Operating temperature

-20ºC a +55ºC

Seal

IP65 – The glands have to be installed to ensure IP65.

Box size

82 x 190 x 40mm

Range (in open field)

50 m

Reaction time (typical)

35ms

Maximum reaction time when

interferences

220ms

Summary of content (4 pages)

PAGE 1
RB3 OSE916 User’s Manual EN Introduction The RadioBand system is designed for Commercial and Domestic door applications where a safety edge is used. The system provides a wireless system replacing spiral cables or energy chain systems to provide the safety signal to the door or gate control panel. The receiver monitors the status of transmitters connected to it. When an obstacle is detected, the RadioBand system puts its output in a safety state.
PAGE 2
Connection OSE 3 wire connection OSE 2 wire connection Starting up Mechanical installation Fix the back of the box to the wall, using the wall plugs and screws supplied. Install the receiver, close to the door and avoid metal surfaces between the receiver and the transmitter. The transmitter and receiver antenna must be parallel to each other for optimum signal reception. Pass the cables through the bottom of the receiver.
PAGE 3
PRESS RPROG PUSHBUTTON LED TURNS ON PRESS TRANSMITTER PROG PRESS RPROG PUSHBUTTON LED TURNS OFF & END PROG ONE BEEP & PROGRAMMED Check the correct operation Press each safety edge connected to assure that the appropriate relay on the receiver is activated. If not, see the Leds and Beeps indication table, to check what is happening and how to solve it.
PAGE 4
Maintenance Total reset In programming mode, keep the programming PROG button pressed down and make a bridge with the “MR” reset jumper for 3s. The receiver will emit 10 warning sound signals and then more at a faster frequency, indicating that the operation has been carried out. The receiver will stay in programming mode. If 10 seconds pass without programming a transmitter, the receiver will exit the programming mode, emitting two 1 sec beeps.