Installation Guide

ManualsBrandsJCM Technologies ManualsElectronicsTransmitter for Automatic Door Safety Edges

Miller Edge, Inc. • www.milleredge.com • info@milleredge.com • East Coast: 800-220-4422 • West Coast: 800-887-3343

IMPORTANT: READ AND UNDERSTAND ALL

INSTRUCTIONS BEFORE BEGINNING INSTALLATION

The Miller Edge RBand Monitored Transmitter is intended to provide a wireless connection between a monitored

sensing edge and a motorized operator. RBand Transmitters and Receivers meets the 2016 UL 325 requirements

for monitored devices and have been certiﬁed as UL 325 Recognized Components. RBand is designed for use with

operators that comply with 2016 UL 325 using a Miller Edge 10K Sensing Edge.

1. PARTS LIST

Kit Contents:

1. RBand Edge Transmitter (RB-TX10)

2. (2) 3.6V AA lithium batteries*

3. (4) #6 pan head transmitter mounting screws

*Replacement 3.6V AA lithium batteries can be

purchased at your local electronics store or via

Miller Edge.

Required:

• Miller Edge RBand 10K Edge Receiver

(Door: RB-D-RX10 or Gate: RB-G-RX10)

• 1/8” ﬂat blade screwdriver

• 1/4” ﬂat blade screwdriver

• Miller Edge 10K (T2/blue band) Sensing Edge

Recommended:

• Multi-meter capable of reading 10KΩ

2. TRANSMITTER: PROGRAM MODE

2-1. Conﬁrm the Receiver is powered up. Prior to mounting the Transmitter, remove the cover and insert the

batteries, noting their polarity. The green LED should blink to indicate that the Transmitter has not been

associated with the Receiver yet [IMAGE 1].

2-2. To enter learn mode, press and hold the Receiver program button for ~2 seconds until the R1 LED turn

on, then release the button.

2-3. Press the Transmitter program button for ~2 seconds. The Receiver should beep. Wait 10 seconds for an

additional beep to indicate that programming is complete.

Note: Refer to Miller Edge RBand Receiver installation instructions for options for additional Transmitters.

INSTALLATION INSTRUCTIONS

Model: RB-TX10

RBAND

MONITORED EDGE TRANSMITTER

RB-TX10_Install_A4_20170531

IMAGE 1. RBand Transmitter

PROGRAM BUTTON

REMOVABLE

SENSING EDGE

TERMINAL BLOCK

(4) CORNER

MOUNTING HOLES

GREEN LED

ALIGNMENT PIN

STRAIN RELIEF FITTING

ALIGNMENT PIN

(2) 3.6V AA LITHIUM

BATTERIES

Summary of content (2 pages)

PAGE 1
RBAND INSTALLATION INSTRUCTIONS Model: RB-TX10 MONITORED EDGE TRANSMITTER IMPORTANT: READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION The Miller Edge RBand Monitored Transmitter is intended to provide a wireless connection between a monitored sensing edge and a motorized operator. RBand Transmitters and Receivers meets the 2016 UL 325 requirements for monitored devices and have been certified as UL 325 Recognized Components.
PAGE 2
IMAGE 2. RBand Transmitter with Door Edge IMAGE 3. RBand Transmitter with Gate Edge 3. TRANSMITTER: INSTALL & TEST 3-1. Strip back approximately 2 inches of outer covering of sensing edge cable, then feed through Transmitter strain relief fitting [IMAGE 1]. Connect the two sensing edge wires to the removable terminal. Dress the wires with a small service loop and tighten the strain relief. Mount unit utilizing the mounting holes at the 4 corners of the Transmitter box.