User's Guide

User manual MUV2 FCC
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
D D
C C
B B
A A
David Clos
22/11/2016
1 1
A3
of
Rev
Sheet
Modified By
Revised By
Date
Date
Scale PCB Ver.
Sheet
Title
DwgGeneral Tolerances
CONFIDENTIAL INFORMATION
RG10.7
IDRev Date Description
Unless otherwise specified
dimensions are
in millimeters ±0,15
angles in grades ±2º
David Clos
30/01/2017
1
BB
PROGRAMMATION SIDE-PROG
A= Transmitter registered in an installation /
B= New transmitter /
émetteur déjà mémorisé dans une installation
nouvel émetteur
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
e.r.p. <1mW
UM_3200901_MUV FCC_Rev01
DONNÉES TECHNIQUES
JCM Technologies S.A. n’approuve aucune modification apportée à l’appareil par l’utilisateur,
quelle qu’en soit la nature. Tout changement ou modification peuvent annuler le droit
d’utilisation de l’appareil par l’utilisateur.
FCC/ISED Regulatory notices
This device complies with Part 15 of the FCC Rules and Industry Canada’s licence-exempt RSS
standards. Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
JCM Technologies has not approved any changes or modifications to this device by the user.
Any changes or modifications could void the user’s authority to operate the equipment.
Interference statement
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: