User's Manual

ManualsBrandsJCM Technologies ManualsElectronicsReader

COD. 1247030-GB / 1.3

FREE 15 R / FREE 30 R

Hands free activator.

TECHNICAL CHARACTERISTICS

FREE 15 R

FREE 30 R

Operating frequency 125kHz

Electricity 12/24V(ac)/(dc) +/- 10%

Consumption 50mA

Radiated power <25mW

Wiring 4 wires

Op. temperature -20ºC - +55ºC

Airtightness IP66

Size 87 x 78 x 15,5 mm 205 x 183 x 14 mm

Enabling area (hands-free mode) 1.5m 3m

INSTALLATION (figure A)

The activator is formed by two parts: a compact box (1) with a plastic front part and the wiring outlet at the back and an

adhesive trim (2). It is designed to be fitted directly to or built into the wall. It is secured by two screws (3), separated by

60mm (ideal separation if it is built-into a standard plug or socket box). The adhesive is fitted over Position 2 in the Figure,

ensuring that the led (5) is visible through the adhesive window. Before fitting the adhesive, screw in and configure the

activator.

N.B.: The activator should not be installed on metal surfaces, as this may reduce the enabling area.

Summary of content (4 pages)

PAGE 1
COD. 1247030-GB / 1.3 FREE 15 R / FREE 30 R Hands free activator. TECHNICAL CHARACTERISTICS FREE 15 R Operating frequency Electricity Consumption Radiated power Wiring Op. temperature Airtightness Size Enabling area (hands-free mode) FREE 30 R 125kHz 12/24V(ac)/(dc) +/- 10% 50mA <25mW 4 wires -20ºC - +55ºC IP66 87 x 78 x 15,5 mm 205 x 183 x 14 mm 1.
PAGE 2
COD. 1247030-GB / 1.3 FREE 15 R / FREE 30 R CONNECTION Connection is made through the wiring from the rear, which is connected directly to the auxiliary power supply. Signal + (12V) - (GND) Sync IN Sync OUT Cable colour Red Black Green White Wiring diagram for the installation of an activator: Where one activator only is to be used, the IN and OUT synch. signals must be short circuited.
PAGE 3
COD. 1247030-GB / 1.3 FREE 15 R / FREE 30 R CONFIGURATION OF CHANNELS AND GROUPS Use the button (4) to configure the activator’s operating mode. Channel configuration: Keep the configuration button pressed down until the number of long red signals is equal to the channel to be configured. For example, if you want to configure channel 2, release the button after the second long red signal. Group configuration: Press the configuration button and keep it pressed down.
PAGE 4
COD. 1247030-GB / 1.3 FREE 15 R / FREE 30 R OPERATING When the equipment is switched on, the LED will make as many red flashes as the channel you have configured and so many green flashes as the group has set. Then the LED will be green fixed. By bringing the tag/transmitter close to the hands-free activator or pressing the button, the activator will send a signal to the receiver in which it is programmed.