User's Manual

ManualsBrandsJCM Technologies ManualsElectronicsReceiver for security gate system

COD. 1248017-GB / 1.2

BASE500

BASE500-1B / BASE500-2B

TECHNICAL CHARACTERISTICS

BASE500-1B / BASE500-2B

Frequency 868,35MHz

Coding High security rolling code

Memory 500 codes

Number of relays 1 / 2 relays

Supply 12/24V ac/dc

Power supply range

9-23 / 22-35V dc

8-16 / 16-27V ac

Relay contacts 1A

Standby/Op. consumption 60mA / 90mA

Op. temperature -20ºC to +85ºC

Watertightness IP54 (with glands IP65)

Size 63x74x25mm

Box dimensions 82x190x40mm

Summary of content (4 pages)

PAGE 1
COD. 1248017-GB / 1.2 BASE500 BASE500-1B / BASE500-2B TECHNICAL CHARACTERISTICS Frequency Coding Memory Number of relays Supply Power supply range Relay contacts Standby/Op. consumption Op.
PAGE 2
COD. 1248017-GB / 1.2 BASE500 INSTALLATION AND CONNECTIONS Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the cables through the bottom of the receiver. Connect the power cables to the terminals marked in the mother board, as indicated. Fix the receiver front to the rear part using the screws supplied. OPERATING The pilot lights are activated every 5 seconds to indicate the correct supply of power to the equipment.
PAGE 3
COD. 1248017-GB / 1.2 BASE500 TOTAL RESET In programming mode, the programming button is held down and the “MR” reset jumper is bridged for 3 secs. The receiver will issue 10 short acoustic warning signals followed by others at a faster pace to indicate that the operation has been successful. The receiver is now in programming mode. After 10 seconds without programming or quickly pressing the programming button, the receiver will exit programming mode, issuing two acoustic signals of 1 sec.
PAGE 4
COD. 1248017-GB / 1.2 BASE500 Self-programming After the receiver has been totally reset, it will be configured with the group of the first radio-programmed transmitter by enabling the hands free mode. Exception: If the receiver has been configured using programming tools, the group may only be changed with the programming tool. Operations On powering the receiver, the led R1 will flash the same number of times as the group number with which it is configured.