Specification Sheet

Control Contractor 50 Series
Control 50S/T and Control 52
Surface-Mount
Subwoofer-Satellite
Loudspeaker System
Key Features:
䉴 Stylish, unobtrusive design fits
into a wide variety of decors
䉴 High fidelity sound
䉴 Selectable 70V/100V for
distributed lines, or low
impedance
䉴 Versatility for either two or four
satellite speakers per system
䉴 Ability to mix and match with
Control Contractor40 Series in-
ceiling models
䉴 Wall-mount brackets included
䉴 Available in black or white
The Control 50 Series
subwoofer-satellite loudspeaker
system provides high fidelity
sound in restaurants, retail stores,
music cafes, health clubs, theme
bars, leisure venues, or any
location where full-range high
fidelity foreground/background
music is required from surface-
mount system.
Control 52 Satellite Speaker
The stylish Control 52 satellite
loudspeaker produces superb
high fidelity sound via a low-
distortion 60 mm (2½ in) driver,
which features a secondary
bucking magnet for high
efficiency, rubber half roll
surround for enhanced bass
performance, 19 mm (0.75 in)
copper clad aluminum wire voice
coil on a vented Nomex
®
former
for high fidelity and reliability,
and a copper-capped pole piece
for more consistent impedance
and extended high frequency
response. The wall bracket allows
each speaker to be angled up to
45° off-axis.
Control 50 Subwoofer
The 150 Watt (600 Watt peak) Control 50S/T subwoofer contains a
high-power, long-excursion, 200 mm (8 inch) driver which features
an extremely robust high-mass cone for extended low frequency
response, a 38 mm (1.5 in) 4-layer copper voice coil for high motor
strength, an aluminum former for good transient response, and a
rubber half roll surround for enhanced bass performance. The
Control 50S/T’s included two-piece easy-mount wall-bracket installs
quickly: The multi-point wall portion of the bracket attached to the
wall and the self-guiding speaker-mounted bracket drops into place
for a secure attachment. A cover over the Control 50S/T terminal cup
keeps wiring neat. The Control 50S/T is mono. The crossover
network built into the subwoofer provides proper signal routing and
four satellite output connectors allow connection of the wires for the
four Control 52 satellite loudspeakers. A Loop Out connector is also
provided on the subwoofer for looping the full-range input signal to
other loudspeakers or to other subwoofer/satellite systems.
System Configuration
Available as packaged system or as separate items, the Control 50
Series is extremely versatile system. The C50PACK system contains
four Control 52 satellite speakers and one Control 50S/T subwoofer
as an easy predesigned system. For smaller floor spaces, the Control
50S/T subwoofer can be utilized with two Control 52 satellite
speakers. The Control 50 system is mono. Both the Control 50S/T
and Control 52 can be intermixed in systems along with the Control
40 Series in-ceiling models – Control 40CS/T subwoofer and Control
42 satellite speaker – to match the form factor requirements of a
wide variety of applications.
Professional Series
76708_JBL.Ctrl50.qxd 6/12/09 2:39 PM Page 1