Control 10 Series Ceiling Loudspeakers Control 12C/T, Control 14C/T, Control 16C/T, Control 18C/T Owner’s Manual & Installation Guide Rev B 1
Table of Contents Product Feature Identification (Control 14C/T Shown) Product Description .................................................... 2 Product Feature Identification ................................... 2 Installation Preparations ............................................. 3 Step-By-Step Installation and Wiring ....................... 3 Painting the Speaker .................................................... 7 Safety Agency Compliance ......................................... 7 Maintenance .
Installation Preparations The entire installation can be accomplished, if necessary, without requiring access above the ceiling. Bracketry for use with either suspended ceilings or sheetrock ceilings is included. The speaker is held securely in place via mounting ears which lock into place. Inputs are attached to a removable locking connector (included) which can be prewired before installing the speaker for ultra-fast snap-on installation.
Step 1 – Cut the Hole. Cutout the circular hole to the cutout hole size listed above. Pull the wiring through the cutout hole. Additional Suspended Ceiling Installation Information Tile Rails: The tile rails are designed to fit either standard 24-inch wide tiles or 600-mm wide tiles. The tile rail pieces do NOT physically attach to the T-grid struts. Instead, the inverted-V shape at the ends of the rails sit OVER the T-grid strut. During normal operation, the rails are supported by the edge of the tile.
Guide to the Pins for Connection -- The removable locking input connector contains 4 terminals, as marked on the connector. The pin functions are listed on the label located on the terminal cover plate. )URP $PSOL¿HU + or Previous Speaker - - To Subsequent + Speaker(s) Figure 9: Using Loop-Through Terminals To + Subsequent Figure 6 Connecteor Pins + - Speaker(s) ‘ Power $PSOL¿HU Pins 1 & 2 are the “+” and “-” inputs to the loudspeaker.
Step 6 – Tighten the Strain Relief Fitting & Close the Terminal Cover Figure 13: Tighten the Two Horizontal Screws to Slide and Tighten the Strain Relief Fitting. Then Tighten the Two Set Screws into the Backcan. (Shown with a single speaker cable) Tightening onto Flexible or Hard Conduit – The supplied fitting accommodates up to 3/8 inch (9.5mm) flexible conduit. Insert the conduit into the strain relief fitting. Tighten the sliding Strain Relief Fitting.
primer is used first. Application can be made by rolling, brushing or spraying. Painting the Speaker Along With the Ceiling – Insert the clear plastic paint shield into the front of the speaker to mask the drivers and internal baffle, paint the speaker, then remove the shield. Painting the Grille – Painting the grille requires removal of the logo prior to painting (the logo should be stuck back onto the grille after painting, making sure it is located in the exact center of the grille).
Maintenance No maintenance is required when installed in accordance with installation and wiring guidelines described in this manual. Product Specifications See product specification sheets for complete specification listings. Control 12C/T Replacement Parts There are no user serviceable parts inside these speakers. Refer servicing to an authorized JBL Service Center. For the name of an authorized Service Center in your area, contact JBL Professional at the address listed below.
Control 14C/T Two-Way 4" Coaxial Ceiling Loudspeaker Professional Series Key Features: 䉴 Components: • 100 mm (4.0 in) high output driver with polypropylene cone and butyl rubber surround 䉴 • 19 mm (0.
䉴 Control 14C/T Two-Way 4" Coaxial Ceiling Loudspeaker Frequency Response, Impedance: 95 40 85 30 75 20 65 10 55 20 100 1000 10000 Ohms SPL (dB) Frequency Response in Half-Space (2, mounted in ceiling) Impedance at 81 (low-impedance) setting 0 20000 Frequency (Hz) Dimensions: Ø 166 [6.5] 164 [6.4] Ø 196 [7.7] 181 [7.1] 196 [7.7] Dimensions in mm (inches) JBL Professional 8500 Balboa Boulevard, P.O. Box 2200 Northridge, California 91329 U.S.A. © Copyright 2013 JBL Professional www.
