X2 USER GUIDE PREMIUM BLUETOOTH EARBUDS ENGLISH
CARRY CASE Carry case instructions . . ....................................................................................3 SETUP Under-ear setup.................................................................................................5 Sound check........................................................................................................14 Over-ear setup.. ..................................................................................................
THE CARRYING CASE To close, place the corner of the lid in and gently massage the opposite corner into place. To open, gently apply pressure to the soft silicon with your thumb until the edge of the lid is revealed. Then pull back the lid to fully remove.
INSIDE THE CARRYING CASE Accessories Packet S x2 M x2 L x2 Charging Cable Cord Management Clips (for later) 4
BASIC Begin with the Traditional Under-ear fit option to determine size.
LEFT & RIGHT ORIENTATION L R NOTE EARTIPS ANGLE INWARDS (FORWARDS) FOLLOWING DIRECTION OF YOUR EAR CANAL. This means that Left & Right orientation is reversed for over-ear, as explained later.
GREAT SOUND PERFORMANCE IS IN SELECTING THE RIGHT SIZE EARTIP WE LOVE GREAT SOUND. MAKE SURE YOU HEAR IT. Because everyone’s ears are different, be sure to try all sizes of eartips. Only with the right size eartips will you enjoy a snug fit & premium sound quality.
COMPLY TM 1 2 3 Premium Comply™ Foam ear tips exclusively designed for Jaybird X2 deliver maximum noise isolation and comfort. Slide Comply Foam tip onto X2 speaker housing. Compress Comply Foam tip by rolling with fingers.
p by 3 4 Premium Ear Tips Secure-Fit: Expands to give you a custom fit and remarkable in-ear retention. Your earbuds remain secure whether you’re in the gym, on the slopes, or on the go. Soft Comfort: Unique memory foam provides all-day comfort, while eliminating in-ear irritation and fatigue. 15-30 seconds Pull ear back. Insert entire foam tip into ear. Hold in place 15-30 sec for foam to expand and create a seal.
BACK IT UP WITH SECURE FIT EAR FINS. The earbuds may slip out of your ear a little. You will lose bass when this happens so use the secure fit ear fins to hold them in place for best sound.
SECURE-FIT L R INSTALL YOUR PREFERRED SIZED SECURE FIT EAR FINS AS SHOWN. Fitting / size selection guidance on next two pages.
SLIDE SECURE FIT EAR FINS ALL THE WAY BACK AND COVER LED (don’t worry, LED glows clearly through the ear fin) 12
LOCK THE TIP OF THE EAR FIN INTO THE TOP OF THE BOWL OF THE EAR AS SHOWN. You should have a snug fit with contact on the lower, back and top portions of the bowl of the ear.
SOUND CHECK PAIR (SET UP) HEADPHONES TO YOUR MUSIC DEVICE, PLAY MUSIC, AND TRY EACH SIZE OF EARTIP TO FIND THE BEST FIT AND SOUND PERFORMANCE. A proper seal is essential for you to fully appreciate the high quality audio of X2. ALTERNATING RED & GREEN VOICE PROMPT: “Searching...” HOLD FOR 4 SEC TO PAIR ON NEED HELP PAIRING? Full pairing details pages 29-32.
ENJOY 15
ADVANCED Over-ear fit option See jaybirdsport.
LEFT & RIGHT ORIENTATION NOTE EARTIPS ANGLE INWARDS (FORWARDS) & UPWARDS, FOLLOWING THE DIRECTION OF YOUR EAR CANAL.
SECURE-FIT TAKE YOUR PREFERRED SIZED SECURE FIT EAR FIN AND INSTALL IN REVERSE DIRECTION WITH POINTED END NEXT TO CORD. IMPORTANT: Check your size preference in under-ear mode first as it can be difficult to tell in overear mode, and may be different to other Jaybird products.
CORD MANAGEMENT CLIPS OVER-EAR MODE REQUIRES LESS CORD, SO BEFORE FITTING, INSTALL THE CORD MANAGEMENT CLIPS TO SECURE THE SLACK FOR A CUSTOMIZED FIT.
MAKE AN “S” SHAPE WITH THE MIDDLE SECTION OF THE CORD.
INSERT CORD INTO 2 OF THE 3 SLOTS IN EACH CLIP AS SHOWN OMITTING THE FINAL ROUNDED SLOTS.
—P ut the headphones on, using index finger to push the tip of the ear fin into place to secure earbuds (a mirror helps the first time). —W ith earbuds secured, adjust position of cord managers (pulling too tight will of course dislodge earbuds, keep a little slack).
Take off headphones, insert cord into the final rounded slots, put headphones back on, now you are ready to go! 23
ENJOY 24
DETAILED INSTRUCTIONS 25
IN THE BOX CHARGING — — — — Charging the battery before use is recommended but not required. X2 ships pre-charged however initial charge will vary. X2 Bluetooth Headphones Jaybird Sport Carry Case 3 pairs Silicone Eartips (S,M,L) 3 pairs Comply TM Premium Foam Eartips (S,M,L) — 3 Pairs Ear Fins (S,M,L) — 2 Cord Management Clips — USB Cable Look for this Bluetooth headset battery status icon top right corner of your iPhone screen to see status of X2 battery.
VOICE PROMPT “BATTERY LOW” Approx 15 mins prior to empty MICRO USB CHARGING Locate fingernail recess and remove back cover to expose micro USB charge point. 2+ hrs for full charge gives 8 hours of playtime. 30 mins charging gives 90 minutes of play time.
PAIRING (SETTING UP) HEADPHONES WITH YOUR PHONE / MUSIC DEVICE 1. W ith headphones turned off, & within 1 meter (3 feet) of music device, press & hold center key for more than 4 seconds until you see alternating red/green flashing of the status indicator and a voice prompt saying “Searching for your music device”. 2. O n your phone/music device, turn Bluetooth on & have it search for Bluetooth devices (see instructions in the phone/music device manual for details). 3.
PAIR MODE: LED alternates red/green HOLD 4 SEC TO PAIR VOICE PROMPT: When you hear “Power on” continue pushing until you hear “SEARCHING FOR YOUR MUSIC DEVICE ...
PAIRING WITH A BLUETOOTH ADAPTER 1. Place headphones and mobile phone within 1 meter (3 feet) of each other. 2. Put the headphones into pair mode as outlined on prior page. 3. If using BAU Universal Bluetooth Adapter put into pair mode also (see BAU manual). 4. Plug the Bluetooth adapter into the music device and play a song. 5. The headphones and adapter will pair automatically (passcode of adapter must be 0000). 6. After successful pairing and connecting, the headphones will say “Headphones connected”.
PAIRING WITH SEVERAL BLUETOOTH DEVICES Paired devices will remember each other unless pairing information is deleted, so there is no need to pair again. X2 can pair and remember 8 phone/music devices. Repeat the steps outlined on prior pages to set-up your headphones with another phone/music device. Note that if a 9th phone/music devices is paired the oldest pairing information is deleted. X2 will connect with the latest connected device.
CONTROLS PUSH 1 SEC PUSH 4 SEC PUSH ADDITIONAL CENTER BUTTON CALL COMMANDS Switch call to X2, Answer 2nd call, end call.
SPECIFICATIONS Bluetooth Version SBC Codec Profile Effective Range Working Time Standby Time Input Voltage Charging Time Dimensions Weight Operating Temp. V2.1 + EDR (newer versions offer no benefits for headphones) Customised SBC codec offers high fidelity without needing APT-X Handsfree v1.6, Headset v1.1, A2DP v1.2 and AVRCP v1.
WARRANTY, CARE & MAINTANCE Full warranty, care and maintenance details at jaybirdgear.com/warranty +1.866.244.3399 WARNING: Due to the isolating characteristics of these headphones do not use while driving, riding a bike or where vehicular traffic is present, or in any other activity where failure to hear surrounding sounds could be dangerous. Use of these headphones at excessive volumes may cause permanent hearing damage. Always turn the volume down before use.
TAKE A MOMENT TO REGISTER YOUR LIFETIME WARRANTY AGAINST SWEAT jaybirdgear.
LISTEN RESPONSIBLY Avoid excessive volume levels and prolonged periods of listening. Do not use around road traffic.
