User's Manual

MAIN CONSOLE Model 45129

1. INTRODUCTION

The Main Console model 45129 is designed to work with the JS sensors. When the sensor is

triggered, it will beep or siren and flash.

In this package, you should find a Main Console, AC Adapter, mounting accessories and user’s

instruction.

Please follow the instructions below to setup your Main Console.

2. INSTALLATION

POWER UP

Install 4 AA batteries (not included) to the unit. Plug in the AC adapter to the unit, the green LED

will on.

PROGRAMMING

You need to do the programming in order to add the sensors to communicate with the Main

Console.

1. With power up the Main Console 45129. Press and hold the Learn button on the Main

Console until it has a long beep. Now release the Learn button and press the Zone#1 button

on the model 45129 once.

2. While the Zone#1 LED is flashing, activate the sensors, the LED on the Zone#1 will off and

emit a long beep indicating it has learned the sensor successful.

3. Repeat the steps 1-2 to learn other sensors to the Zone#2, 3 and 4 respectively.

CLEAR THE PROGRAMMED UNIT

You cannot delete one learned device from the Main Console in each zone at a time. You must

clear all the learned sensors that are currently communicating with the Main Console in that zone,

then re-program the ones you want to keep.

1. With power up the Main Console 45129. Press and hold the Learn button on the Main

Console, then press the zone that you would delete the sensor.

2. While that zone LED is flashing twice and emit 2 beeps, this will erase all “learned” devices in

that zone.

3. Repeat the steps 1-2 to delete the sensors from other zones you would delete the sensor.

TESTING

After the sensor is installed in place, and the Main Console is powered up, you may test the

operation of both units.

While the Main Console is set to Alert Mode (slide the mode switch to top side). If the activated

sensor is programmed to zone 1, zone 1 LED should flash and emit a single beep continuously.

The zone LED will keep flashing until the sensor is back to standby condition (i.e. closed door).

If the activated sensor is programmed to zone 4, zone 4 LED will flash, and the Main Console will

emit a continuous “4 beeps”.

While the Main Console is set to Chime Mode (slide the mode switch to middle). If the activated

sensor is programmed to zone 1, zone 1 LED should flash and emit a single chime. The zone

LED will keep flashing until the sensor is back to standby condition (i.e. closed door).

While any programmed sensor is activated, the Main Console will beep or chime and the

corresponding zone LED will flash.

MODE SELECTION

PAGE 1
MAIN CONSOLE Model 45129 1. INTRODUCTION The Main Console model 45129 is designed to work with the JS sensors. When the sensor is triggered, it will beep or siren and flash. In this package, you should find a Main Console, AC Adapter, mounting accessories and user’s instruction. Please follow the instructions below to setup your Main Console. 2. INSTALLATION POWER UP Install 4 AA batteries (not included) to the unit. Plug in the AC adapter to the unit, the green LED will on.
PAGE 2
You can select the Main Console in Alert or Chime or OFF mode by switching the mode switch to “Alert” or “Chime” or “OFF” position. MUTE When a sensor is triggered for a longer period of time, you may stop the beeping by pressing the mute button. The Main Console will beep again if it receives another signal. ALARM MODE The Main Console provides the alarm feature, instant alarm and delay alarm. To arm the Main Console to Instant Alarm: 1. Press the current MPIN [1111]. 2. Press and hold the [Arm] button. 3.
PAGE 3
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.