Assembly Instructions

Surge Protector
Instructions
Read and follow all instructions and warranty information
prior to use to ensure protection to connected equipment
and warranty compliance.
WARNING: Do not exceed max loading weight of 1lb. Product may
fail to remain fastened potentially damaging your phone unless
permanently installed using mounting screw.
Temporary Installation:
1. Remove the mounting screw from the surge protecter that is
needed for permanent installation.
2. Plug the surge protector into a standard grounding duplex wall
receptacle, covering both outlets, by fully inserting the plug and
ensure that there are no exposed conductors.
3. The surge protector will now be providing power and surge
protection.
4. Make sure electronic equipment is turned off before plugging into
the surge protector outlets. Do not use extension cords to connect
equipment to the surge protector.
5. Connected equipment can now be turned on.
6. Hold the surge protector firmly against wall when removing plugs to
prevent it from pulling loose.
Permanent Installation:
1. Disconnect power to the receptacle at the service panel.
2. Remove wall plate mounting screw from existing grounded duplex
wall outlet and discard. DO NOT remove wall plate
3. Plug surge protector into wall outlet and secure with center
mounting screw provided.
4. Restore power at service panel.
5. The surge protector will now be providing power and surge protection.
6. Make sure electronic equipment is turned off before plugging into
the surge protector outlets. Do not use extension cords to connect
equipment to the surge protector.
7. Connected equipment can now be turned on.
NOTE: In the event that the protection capacity is exceeded by
a power surge or the protection components expire*, the power
will be permanently shut down to the outlets, ensuring surge
protection for your electronic equipment. At this
time, the surge protector has reached end of life and must
be replaced.
Surge protector — limited-lifetime warranty
Jasco Products Company warrants this surge protector to be free
of defects in design, assembly, materials and/or workmanship for
the life* of the surge protector. If such a defect should arise during
the life of the surge protector, Jasco will, at its option, either repair or
replace the surge protector without charge. This warranty does not
cover damage caused by accident, misuse or alterations to the surge
protector, or natural disasters of any kind.
NOTE: Do not use this product in any way with a generator, heater,
sump pump, water-related device, life support device, medical device,
car, motorcycle, or golf cart battery charger. This product is for indoor
use only and in a dry area. All warranties of this product are null and
void if used in any manner mentioned above.
*This surge protector, like all surge protectors, has a finite lifespan. Even under
normal circumstances and in the absence of defects, the product’s life will expire
when the surge protector’s component capacity has been exceeded, thereby
ceasing to provide protection from surges. In this event, the limited-lifetime
warranty is no longer valid and the surge protector should be replaced.
Warranty replacement procedure
1. Call Jasco Customer Information Center at 1-800-654-8483 to
receive a Return Authorization Number (RA#), shipping instructions
and a prepaid return address label.
2. After you receive the prepaid return address label, return the Jasco
surge protector, freight prepaid, to Jasco. Surge protectors returned
to Jasco must have an RA# included in the mailing address to be
accepted.
3. The original purchaser will be asked to send the surge protector,
a copy of the sales receipt for the product, your name, address,
phone number and a description of the problem.
Connected equipment warranty
Equipment replacement guarantee for surge model: 43645
Maximum warranty amount: $50,000 (USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection when
lightning strikes nearby power lines, the house, service entrance or antenna. The
warranty is void if a power disturbance damages your equipment through the
coax, phone or network lines.
Jasco will pay up to the maximum warranty amount offered for the
surge protector purchased to repair or replace up to an amount equal
to the fair market value or the original purchase price, whichever is
less, of your electronics equipment, if damaged by a transient surge
within the life of the surge protector, while properly and directly
connected to this surge protector. JASCO DISCLAIMS AND ASSUMES
NO LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL
DAMAGES, INCLUDING BUT NOT LIMITED TO, LOSS OR DAMAGE TO
SOFTWARE OR DATA OR DAMAGES OR COSTS ASSOCIATED WITH
BUSINESS INTERRUPTION OR OTHER DAMAGES DUE TO LOSS OR
DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do
not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have
other rights that may vary from state to state.
Jasco reserves the right to inspect the surge protector involved in an
incident associated with a warranty claim, along with the site where
the damage occurred and all equipment plugged into the surge
protector or nearby AC outlets. The surge protector, damage site and
any equipment involved must remain available for inspection until the
claim is finalized.
Jasco reserves the right to subrogate under any existing insurance
policies the claimant have. This warranty is valid and available only to
the original consumer purchaser of the product.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer’s warranty,
extended warranties or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be certified by a nationally
recognized testing laboratory.
2. The Jasco surge protector must be plugged into properly wired
and grounded outlets, no extension cords, adapters, other ground
wires, or electrical connectors may be used, with the sole exception
of other standard Jasco 120V products approved for that use. The
installation must comply with all applicable electrical and safety
codes set forth pursuant to the National Electrical Code (NEC).
3. Any claim under the warranty policy must be made within
15 days of the date of the alleged damage to the
connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A. All equipment eligible for warranty coverage must be plugged
directly into the Jasco surge protector. Equipment connected to
the protected equipment, but not plugged directly into the surge
protector will not be covered.
B. The equipment must have been damaged by a covered power
disturbance that passed through the Jasco surge protector.
C. The Jasco surge protector must be found defective.
D. The Jasco surge protector’s protection capacity must not have
been exceeded.
E. All connected equipment must have been used under normal
operating conditions and according to any
manufacturer’s instructions.
Connected equipment claim procedure
1. Call Jasco Customer Information Center at 1-800-654-8483 to get
a Return Authorization Number (RA#), shipping instructions and a
prepaid return address label.
2. After you have received the prepaid return address label, return the
Jasco surge protector, freight prepaid, to Jasco. Surge protectors
returned to Jasco must have an RA# included in the mailing
address to be accepted.
3. Jasco will determine whether the damage to your equipment
is covered by this warranty policy. If you are covered, a claims
adjuster will contact you and Jasco will do one of the following at
its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged equipment.
d) Reimburse customer the initial purchase price of the damaged equipment
MADE IN CHINA
GE is a trademark of General Electric Company and is under license
by Jasco LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime warranty.
Visit www.byjasco.com for warranty details.
Questions? Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM—8PM CST.
43645 V1
01/18/2019
WARNING: Avoid using ring holders or phone cases
that contain metal. Metallic objects should not be
placed between the wireless charging pad and your
phone – metal can interrupt the charging process, as
well as create heat, posing a burn risk.
Blue LED glows
when device is
charging.
Red LED glows if device is not
centered or horizontal and
charging. Please realign.
LED will turn off
when device is
fully charged.
equipment (customer to provide dated bill of sale).
4. Jasco retains the right to determine whether the damage to the
connected equipment is due to Jasco surge protector failure by
requesting that damaged equipment be sent to Jasco
for inspection.
FCC statement
Notice: Federal Communications Commission (FCC) requirements,
Part 15
This device complies with Part 15 of the (FCC) rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes of modifications not expressly approved by
the grantee of this device could void the user’s authority to operate
the equipment. This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Qi™ Wireless Charger
The Qi™ charger allows you to conveniently charge your compatible
devices without the hassle of cables.
Warning: Avoid using ring holders or phone cases that contain metal.
Metallic objects should not be placed between the wireless charging
pad and your phone – metal can interrupt the charging process, as
well as create heat, posing a burn risk.
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• FULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL
RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER
WATER-RELATED PRODUCTS
• GENERATORS, POWER INVERTERS,
HEATERS, SUMP PUMPS, OR CAR,
MOTORCYCLE OR GOLF CART
BATTERY CHARGERS
• MEDICAL LIFE-SUPPORT PRODUCTS
WARNING
Certified by WPC
(Wireless Power Consortium)
CAUTION
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT USE THIS DEVICE WITH A
RECEPTACLE IN WHICH THE SLOT OPENINGS
DO NOT ALIGN WITH THE BLADES. NOT FOR USE
WITH GROUND-FAULT CIRCUIT-INTERRUPTER
RECEPTACLES OR RECEPTACLES WITH
INDICATOR LIGHTS OR CONTROLS.
Using the Qi Wireless Charger
Place your phone on the center of the wireless charger. The charger’s
blue LED lights will turn on to show that your phone is charging. If red
LEDs turn on, reposition your phone on the wireless charger.
Make sure your phone is lying flat on the charger. Remove any objects,
such as PopSockets® or ring holders, that may be between your
phone and the charger. If red LEDs turn on, remove any metallic objects
between your phone and the charger. If your phone is in a case, it could
be interfering with the wireless charge. Remove the case and try again.
WARNING: Do not exceed max loading weight of 1lb. Product may fail to remain
fastened potentially damaging your phone unless permanently installed using
mounting screw.