SPECIFICATION Description: SmartCard+NFC Reader Module Model:AP-SCRNFCX-XX(X means 0-F, hexadecimal number) 2
Index NO. ITEN PAGE 1. General Description 4 2. Features 4 3. Support the following operating modes 4 4. System requirements 4 5. General Specifications 5 6. Connector Pin List 5 7. PCBA Dimension 6 8. USB Device VID/PID and Firmware Version 7 9.
1. General Description The 15KV_Smart Card_NFC module is a highly integrated transceiver module for contactless reader/writer communication at 13.56 MHz. A dedicated Flash code is implemented to handle different RF protocols by an integrated microcontroller. The system host controller communicates with the 15KV_Smart Card_NFC module by using the USB link. The protocol between the host controller and the 15KV_Smart Card_NFC module, on top of this physical link is the CCID protocol 2.
Support by the following OS through the PCSC-Lite driver: – GNU/Linux using libusb 1.0.x and later – Mac OS Leopard (1.5.6 and newer) – Mac OS Snow Leopard (1.6.X) – Solaris – FreeBSD 5. General Specifications Bus-powered - +5V +/- 5%, 500mA Average Power Consumption Standby Mode: 0.12Watt Active/Read Card Mode: 0.24 Watt Operational environment – Operating Temperature: -10°~60° – Operating Humidity: 10%~90% – Storage Temperature: -20°~70° – Storage Humidity: 10%~90% 6.
7.
8. USB Device VID/PID and Firmware Version VID/PID: 0x1FC9/0x0102 F/W Ver: 0110 9. Block Diagram USB Host Crystal 27.12MHz Smard Card NFC PN746 ANT, 13.56MHz 10.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.