User's Manual

DMSS2.4GHz4chReceiver
(Integralantennatype,supportingbi-directionalcommunications)
DesignedforParkFlight
*NotethatDMSSsystemarenotcompatiblewithDSM-2norDSM-Jsystems.
2.4GHzBandCharacteristicsandReceivingRadioWave EZBINDSystem TelemetrySystem
Troubleshooting
OperationManual
ReceiverSpecs
RG411B
DMSSsystem
3.5g
35.5×18×9㎜
4.8Ｖ
4.5-8.5V
Built-inAntenna
Configuration
● RG411BReceiverMainUnit ● OperationManual(Thisdocument)
If,aftercompletionofbinding,thereceiveristurnedonfirst...
[EZBINDSystem]isauniquesystemdesignedforthe
receiveroftheParkFlight.WiththeEZBINDSystem,
bindingcanbecarriedoutwithoutusingabindingplug.
BindingMethod
SENSOR
・Istheremainingbatterypowerofthetransmitterandreceiveradequate?
・
Hasyourreceivermodelbeenchanged?
Whenthereceiverdoesnotoperate,checkthefollowingpoints.
Whenthebindingdoesnotcompletesuccessfully,checkthefollowingpoints.
DATA:RG411Bmanualrev.C
DATE:2014.02.06
PRINT:SANEI
LocationofRG411Bintegralantenna
Makesuretosetfailsafeaftercompletionofthebinding
Inthesituationwherethereceiverhasbeenattached
directlytoamaterialwhichshieldsradiowaves,suchas
carbonormetal,thereceivingsensitivitywillbe
considerablyreduced.
Whenthereceiveristobeinstalledonshieldingmaterial,
separatethereceiverasfaraspossible.
Theintegralantennaislocatedonthefrontsurfaceofthe
board.Ifthereceiverisinstallednearshieldingmaterial,
receiversensitivitywillbeconsiderablyreduced.
Pleasetakeadequatecareofthereceiverposition.
Antenna
[AbouttheTLLogo]
[AbouttheEZBINDLogo]
Thislogoisonlyincludedon
productsthatincorporateJR
EZBINDSystem.
ThankyouforpurchasingJRproduct.
Toallowcorrectandsafeuseofthisproduct,becertainto
readthisoperationmanual.
Brown
Red
Orange
TurnthereceiverONwhilethetransmitterisonthestatusofthe
step2.Afterafewseconds,thebindingwillstartandtheLEDbegins
toflash.WhentheLEDstopsblinking,
thebindingoperation
hasbeencompleted.
Makesuretoturnonthe[transmitter]firstaftercompletionofthebinding
Features
・DMSSsystemisnotinterferedbycrossmodulationnor
intermodulation.
・Atelemetrysystemiscapableoffeedingbackinformationsuch
astheaircraftremainingbatterypower.
・ItispossibletoconfirmthereceivingconditionbystatusLED.
・Supportisprovidedforthefailsafesettingsinthetransmitter.
・EZBINDSystemisintegrated(nobindingplugisneeded).
Thislogoisonlyincludedon
productsthatsupporttheJR
TelemetrySystem(bi-directional
communications).
ProductNumber:
ReceivingSystem:
Weight:
Dimensions:
RatedVoltage:
OperatingVoltage:
Remarks:
ReceiverBattery
(Soldseparately)
Sensor
(Soldseparately)
Connection
Diagram
SwitchHarness
(Soldseparately)
Y-Harness
(Soldseparately)
SensorConnections
Forconnectingthesensor,
connecttheY-Harness
(soldseparately)tothe
[BIND/BATT/SENS]terminal.
*Itwillnotbenecessaryto
carryoutbindingforthe
sensor.
JapanRemoteControlCo.,Ltd.
Inordertoprotectagainstinjurytousersorthirdparties,ordamageto
property,pointsthatmustcertainlybeobservedareshownbelow.
■PleaseReadBeforeUse
Toallowsafeuse,becertaintoobservethefollowingpoints.
●BasicPrecautionsforSafeUseofthe2.4GHzSystem
(1)The2.4GHzbandisnotafrequencyexclusivelyforusewithRCairplanes.This
frequencybandisincommonusewiththeISM(industry,science,andmedical
care)bandwhichiswidelyusedforshort-distancetransmissionssuchas
microwaveovens,wirelessLAN,digitalcordlessphones,audio,gaming
devices,cellphoneBluetooth.Therefore,theresponseofthe2.4GHzsystem
maybereducedinurbanareas.Further,asitalsoisusedforhamandlocalarea
radiocommunicationformobileidentification,pleasepayattentiontothe
possibleinfluencesfromthese.Intheeventofanyadverseradiowave
interferenceonanexistingwirelessstation,immediatelystopemittingradio
wavesandtaketheinterferenceavoidancemeasures.
(2)Atracetracksandairfields,minimizetheuseofdevicesthatcanaffectthe
transmitter/receiverandbesuretoconfirmthesafetybeforehand.Also,always
followtheinstructionsofthefacilitystaff.
(3)Ifanaircraftisallowedtopassbehindabuilding,pylon,trees,etc.the
radio-waverangeisblocked,theresponsemaydrop,evenresultinlosing
control.Alwaysletaircraftrunorflywithinarangethatyoucanvisually
observe.
ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:
(1)thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,
includinginterferencethatmaycauseundesiredoperation.
Warning:Changesormodificationstothisunitnotexpresslyapprovedbythepartyresponsibleforcompliance
couldvoidtheuser'sauthoritytooperatetheequipment.
NOTE:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuant
toPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmful
interferenceinaresidentialinstallation.Thisequipmentgenerates,usesandcanradiateradiofrequencyenergy
and,ifnotinstalledandusedinaccordancewiththeinstructions,maycauseharmfulinterferencetoradio
communications.
However,thereisnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoes
causeharmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipment
offandon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:
1.Reorientorrelocatethereceivingantenna.
2.Increasetheseparationbetweentheequipmentandreceiver.
3.Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
4.Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
ThisdevicecomplieswithIndustryCanadaLicence-exemptRSS-210.Operationissubjecttothefollowingtwo
conditions:(1)thisdevicemaynotcauseinterference,and(2)thisdevicemustacceptanyinterference,
includinginterferencethatmaycauseundesiredoperationofthedevice.
DANGER!
WARNING!
CAUTION!
■ Inordertoestablishcommunicationswiththetransmitter,binding(pairing)mustcertainlybecarriedout.Inthissection,anexplanationisgivenofthebinding.
・Istheremainingbatterypowerofthetransmitterandreceiveradequate?
・Isthedistancebetweenthetransmitterandreceivertooclose?
・Whentheprocedureiscarriedoutonthetopofadeskorbenchthatis
madefrommetal,bindingmaynotbesuccessful.
LEDLightingLocations
Keepapproximately40m
awayfromtheaircraft
RangeTest
Operatetheservoandconfirmthatthebindinghavebeen
successfullycompleted.Notethatwhencarryingoutarangetest,after
settingthetransmittertothe
reducedpoweroutputcondition,
maintainadistanceofapproximately
40mfromtheaircraftandmove
aroundittoconfirmthatoperation
canbecarriedoutfromalldirections.
*Toreducethetransmitterpoweroutput,
pleasereadthetransmitteroperation
manual.
Aftercompletingabindingoperationofthetransmitterand
receiver,turningonthereceiverfirstwillleadittoBinding
StandbyConditionin[threeseconds].TheBindingStandby
Conditionwilllastfor[fiveseconds].
*Turningonthetransmitterfirstwillstartnormal
transmissionoperation.
*Ifyouhavechangedyourreceivermodel.Pleasecarryout
anotherbindingtoestablishnewcommunication.
WhileyourreceiverisonBindingStandbyConditionbased
ontheEZBINDfunction,ifanothertransmitterlocated
nearbystartsabindingoperation,bindinginformationof
yourreceivercouldbeoverwritten.Toavoidsucha
significantrisk,makesuretoturnonyourtransmissionfirst.
Afterbindingiscompleted,makesuretosetfailsafe
usingtheFailSafefunctiononthetransmitter,and
checktoseeifthefailsafeworksproperly.
TheTelemetrySystem(bi-directionalcommunicationsystem)is
pre-installedonRG411B,andvoltageinformationofareceiver
batteryistransmittedtothetransmitter.Byaddingasensorwhichis
optionallyprovided,otherinformationincludingtemperatureand
rotationalspeedcanbecommunicated.
Suchinformationthatcanbedisplayeddiffersdependingonatype
oftransmitteryouuse.Beforeinstallinganadditionalsensor,check
functionsofyourtransmitter.
Displaythe[BIND]SettingScreeninthetransmitterSystem
SettingMode.
*ThefigurebelowshowstheXG8screenshot.
[SituationoftheXG8]
BindingSetting
Screen
Next,matchthecursor[]to“BIND”displayedonthe
BindingSettingScreenofthetransmitterandpressthe
dial.
FollowingdiagramshowsdisplayonXG8.
AboutHarnessConnections
Connecttheharnesseswith
appropriatedirections.
Abrowncableshouldbeon
thesideof[]andan
orangecableshouldbeon
thesideof[].
Notfollowingthisadvicecarrieshighriskofdeathorseriousinjuryto
theuserorthirdparties.
Notfollowingthisadvicemayresultindeathorseriousinjurytheuser
orthirdparties.
●Donotusethisproductintherainaswatermaycauseelectronicdevicestomalfunction.
●Thisproductcarriesariskofinjuryduetoheat,fire,andelectricshock.
●Neverdisassembleormodifythisproduct.
●Whenturningonthereceiver,theengine(ormotor)canstartrotatingathighspeed,
causinginjury.
●Beforeturningon,alwayssetthetransmitterthrottlesticktothelowestspeedposition.
Turnonthetransmitterfirstthenthereceiver.
Toshutdown,switchoffthereceiverfirstandthenthetransmitter.
Notfollowingthisadvicemaycauseinjurytotheuserorthirdparty(or
causedamagetoproperty).
■Ifyouhavefurtherquestions,pleasecontactyourlocaldealerorJRdistributorinyourcountry.
●Isthereenoughbatteryvoltageforboththetransmitterandreceiver?
●Isthereanyfuelspillageonthereceiver,servos,etc.thatwascausedbyleakagefromthefuel
tank?Isthereenoughfuel?
●Checkthatnolinkageinterfereswiththeaircraftbody.Conductavibrationtestbyrestraining
themodelandsettingtheengine(ormotor)tofullpowerwhilstkeepingyourhandswell
clearofthepropeller.Checkthateachcontrolsurfacemovescorrectly.Fortheinitialflightsof
anewmodelalwaysflyinasafeplace,avoidflyingatgreatdistance,andkeepthemodel
closetothelandingareaforseveralminutesuntilyouarefullyconfidentthatthereceiveris
operatingcorrectly.
●Donotusethisreceiverincombinationwithothermanufacturersproductssuchasservos,
gyrosetc.
●Neverallowthereceivertoreceiveastrongimpactastheelectroniccomponentsinthe
receiveraresusceptibletodamage.
●Ifdegradedservomovementisdetected,stopoperatingimmediately.Identifythesource
oftheproblembeforefurtheroperation(checkbatteryvoltage,etc).
●Donotusetheproductinthefollowinglocations,astherewillbeariskofanout-of-control
conditionoraccident:
•Whereinterferenceexists.•Wherethereistrafficpassingnearby.
•Nearhigh-tensionelectriclines,buildings,orinmountainousareas,etc.
•Nearhousesorpeople.•NearradioorTVtransmitters
●Ifthereceiverbecomessubmergedinwater,itmayappeartooperatenormallyafterbeing
fullydried.However,itmaymalfunctionatalatertime.Donotcontinuetousetheproduct
‒contactyourJRdistributortoarrangeaninspection.