JRN-130K 3G/GSM IT Controller User Manual Doc# : AN-1490012-2 Ver.1.02 Date: Oct 15, 2014 @Copyright Japan Radio Co., Ltd.
3G/GSM IT Controller JRN-130K History Date Sep 16, 2014 Oct 16, 2014 Oct 16, 2014 Number 1.00 1.01 1.
G/GSM IT Controller JRN-130K 3/19 AN-1490012-2 Index 1 2 3 4 5 6 7 8 9 Introduction.............................................................................................................................. 4 Composition ............................................................................................................................ 5 Function ..................................................................................................................................
3G/GSM IT Controller JRN-130K 1 4/19 AN-1490012-2 Introduction 3G/GSM IT Controller (JRN-130K) is a vehicle small terminal to have the GPS measureme nt function and the 3G/GSM communication function, and to use it for management and posit ional information track / theft pursuit etc. of the vehicle. As a communications protocol TCP/IP are mounted. The terminal made by the Gemalto’s PHS8-P is installed. 1.1 Overview The main specification is presented as follows. No.
3G/GSM IT Controller JRN-130K 2 5/19 AN-1490012-2 Composition NO.
3G/GSM IT Controller JRN-130K 3 6/19 AN-1490012-2 Function (1) Operation in ACC OFF executes the following. -1. Send data in daytime and nighttime. -2. Respond to calling from the server. -3. Acquisition of information on the actual location by GPS, and Generation of warning outside area. (2) Storage of operation data (3) Timer Even if the main source of power is cut, the date and time are maintained. (4) Backup The re-charge battery is installed.
3G/GSM IT Controller JRN-130K 4 7/19 AN-1490012-2 Product specification 4.1 Common Specification NO. Items 1 2 3 4 5 Power supply voltage Battery pack DC+20 to +32V SIM Interface Current 1.8V/3.0V Circumference environment Specification performance NiMH rechargeable battery NBB-1300(1300mAh/6.0V) Communication: max current Less than 400mA(+25℃) Idle:7.
3G/GSM IT Controller JRN-130K 4.1 Serial Interface Specification (1) A. DTE CAN NO. Items 1 Data transmission 2 Speed 3 Communication format 4 Switch to the RS-232C (1) B.
3G/GSM IT Controller JRN-130K 4.1 GPS NO. 1 2 3 4 5 6 7 8 Receiver Specification Items Model Receiving system Received frequency Land survey system Time system Positioning accuracy Position Speed Direction Speed T.T.F.F (Without signal discontinuation) Open skies Specification performance CCA-705JZ (JRC) Max 16hannel (high-speed search channel) 1575.42MHz(L1)、C/A code WGS-84(Default) UTC 5.3m 2DRMS 0.04m/sec. RMS Less than 0.14°RMS 1 sec Hot start: 4s Warm start: 33s Cold start: 35s (Speed 60km/h) typ.
3G/GSM IT Controller JRN-130K 10/19 AN-1490012-2 4.1 External connector specification NO. 1 Items Power/Serial connector 2 GPS antenna connector 3 Communication antenna Specification performance XMR (JST) Model : XMR-09V [Cable side connector model : XMP-09V(JST)] GT5 (HIROSE) Model : GT5P-1PP-HU(70) BNC (Yuetsu Seiki) Model : BNC-PJ-C0-6F 4.1 Software JRN-130K application software external I/F specifications is prescribed about the command list a nd block structure about software.
3G/GSM IT Controller JRN-130K 5 Block Diagram 11/19 AN-1490012-2
3G/GSM IT Controller JRN-130K 6 12/19 AN-1490012-2 External Interface 6.1 External Interface Specification Pin Assign NO Name 1 GND 2 Moni-Tx 3 Moni-Rx 4 CAN H 5 CAN L 6 CAN_EN 7 GND 8 ACC 9 BAT Remarks GND Monitor→ITcontroller ITcontroller→Monitor CAN Low-Level Voltage I/O CAN High-Level Voltage I/O CAN Enable GND ACC signal Main battery 6.2 GPS Antenna Connector Pin Assign NO. 1 2 Name RF GND Remarks Receive GND 6.1 Communication Antenna Connector Pin Assign NO.
3G/GSM IT Controller JRN-130K 13/19 AN-1490012-2 6.1 Equivalent circuit BAT DC/DC Converter 9 to PWR SPLY +3.
3G/GSM IT Controller JRN-130K 7 Outline 14/19 AN-1490012-2
3G/GSM IT Controller JRN-130K 8 15/19 AN-1490012-2 Option 8.1 GPS antenna (1) Specification NO. 1 2 3 4 5 6 Items Power supply voltage Consumption current Cable Temperature range of operation Storage temperature range Humidity 8 9 Received frequency range Polarized wave Profit 10 11 12 Output impedance OUTPUT VSWR Connector 7 Specification performance 2.7V to 3.3V 12mA to 30mA 1.
3G/GSM IT Controller JRN-130K 8.2 16/19 AN-1490012-2 Communication antenna (1)Specification No. 1 2 3 4 5 Items Specification performance DP-BR0-DSC(BNC) λ/2 Shortened type Dipole antenna For the indoor antenna, double-sided tape attachment approximately 70g RoHS and ELV 6 Model Antenna type Purpose Weight Environmental Regulation Frequency 7 Nominal impedance 50Ω 8 VSWR 2.3 at the end of the cable. It is measured in free space. 9 Peak gain A,B,E,G-(1) cable. C,D,F,G-(2) cable.
3G/GSM IT Controller JRN-130K (2)Outline NO. 1 2 3 4 5 Items Specification performance Case 1.5D Coaxial cable BNC Two-sided adhesive tape Label AES 2.
3G/GSM IT Controller JRN-130K 9 18/19 AN-1490012-2 Compliance with FCC and IC Rules and Regulations ・FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation.
3G/GSM IT Controller JRN-130K 19/19 AN-1490012-2 (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil d oit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptibl e d'en compromettre le fonctionnement. Le présent émetteur radio (IC: 768B-JRN130K) a été approuvé par Industrie Canada pour f onctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible max imal et l'impédance requise pour chaque type d'antenne.