XT3 Series™ Quick Start Guide Technology at Work.® 091019XT3 www.janam.
XT3 Series Quick Start Guide Copyright 2019 Janam Technologies LLC. All rights reserved. XT3 Series, Janam and the Janam logo are trademarks of Janam Technologies LLC. Other product and brand names may be trademarks or registered trademarks of their respective owners. Janam Technologies LLC assumes no responsibility for any damage or loss resulting from the use of this guide.
Content and Additional Resources To help you get started with your XT3 Series mobile computer, this guide features: - Hardware Overview - Getting Started A. Install the Battery B. Charge the Battery C. Remove the Battery + Access Card Slot - Battery warnings and safety guidelines Contents of this guide are subject to change. For software updates and information, visit www.android.com.
Hardware Overview 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Power key 3.
Hardware Overview 3 1 2 4 1. Camera 2. Camera flash 3. Speaker 4. Landyard hole 5.
Getting Started Important Note: The main (removable) battery charges the internal backup battery with or without an external power source. When discharged, the backup battery requires approx. 1.5 hours to recharge. Caution: All user data will be lost if the main battery is removed before the internal backup battery is properly charged. It is recommended you check that the backup battery capacity is at 100% prior to removing the main battery.
Getting Started (continued) C. REMOVE THE BATTERY + ACCESS CARD SLOT 1. Slide the battery door lock switch until it is open. 2. Remove the battery by lifting up the battery. 3. SIM / SAM / MicroSD card slot is now accessible in upper part of housing.
Battery Warning CAUTION IF MISUSED OR MISTREATED THE BATTERY MAY PRESENT A RISK OF FIRE OR CHEMICAL BURN. RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. ATTENTION Un remplacement inadéquat de la batterie ou une utilisation incompatible de l’appareil peut présenter des risques de brulures, d’incendie, d’explosion ou d’autres dangers. Jetez les piles en lithium-ion conformément aux régulations locales. BATTERY SAFETY GUIDELINES.
Regulatory www.sar-tick.com Body-worn Operation This device was tested for typical bodyworn operations with the Front & back of the device kept 0.59 inches (1.5cm) between the user’s body and the Front & back of the device. To comply with FCC RF exposure requirements, a minimum separation distance of 0.59 inches (1.5cm) must be maintained between the user’s body and the Front & back of the device. Any beltclips, holsters, and similar accessories containing metallic components may not be used.
Regulatory IC Warning This device complies with Industry Canada license-exempt RSS standard(s).Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.