LPT20 Series mobile computer Quick Start Guide
Features front and side views 4 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
Features 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.
Getting started installing card and battery Installing MicroSD card 1. 2. 3. Remove battery if necessary Insert MicroSD card into the card slot Make sure the card connector (the golden contacts) should be at the front of insert Installing battery – – – – – If battery cover is installed on the device, slide the battery latch to the left.
Getting started installing card and battery Removing battery 1. 2. 3. Slide the battery latch to the left.
Getting started Installing handstrap 1. 2. 3. Separate the velcro of the handstrap. Feed the loose end of the extended handstrap through the handstrap clip Wrap the handstrap around the clip and fasten together to close the strap Calibrating screen 1. 2. 3.
Getting started Enabling & disabling WiFi Enabling WiFi 1. 2. 3. 4. Tap Start Menu, then tap and hold the Settings Select Network Connections Tap and hold AR6K_SD1 icon, make sure it is Enable Double click the Network icon on the status bar, pick the desired AP and setup as the wireless AP properties as usual Disabling WiFi 1. 2. 3.
Getting started Enabling & disabling BT Enabling Bluetooth 1. 2. 3. 4. 5. Tap Start Menu, then tap and hold the Settings Select Control Panel Double click Bluetooth Device Properties icon Pick the Tools menu and then select Turn on Bluetooth item Select Search Device and carry out bluetooth device operations as usual Disabling Bluetooth 1. 2. 3. 4.
Getting started Soft and hard reset Performing soft reset 1. Slide the battery latch to the left and grasp the battery cover and remove it 2. 3. Use a stylus to press the reset key and release The device is reset Performing hard reset 1. Slide the battery latch to the left and grasp the battery cover and remove it 2. 3. 4. 5.
Getting started Refreshing ROM Refreshing LPT20 ROM 1. 2. 3. 4. 5. 6. 7. 8. 9. Copy NK.bin, EBOOT.nb0 and splash.bin (optional) to the root directory of the microSD card Open the battery cover, remove the battery Insert the microSD card Press and hold the left and right side Scan / Action button Install the battery to the battery compartment Continue to press and hold the left and right side Scan / Action button until the Update Screen appears Once NK.bin, EBOOT.nb0 and splash.
Getting started Capturing data 65o 65o
Getting started Battery warning Battery safety guidelines 1. 2. 3. 4. 5. 6. 7. 8. 9. Use manufacturer’s original battery and charger only. Any incompatible battery or charger may result in in a fire, explosion, or other hazard. Do not disassemble or open, crush, bend or deform, puncture, or shred the battery Do not short circuit a battery by allowing conductive materials to contact the battery terminals.
Statement of Compliance CE Marking and European Economic Area (EEA) Hereby, Portable Innovation Technology Ltd. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive, 1999/5/EC. Radio Frequency Interference Requirements-FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
Warning Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.