XG4 Series™ Quick Start Guide Technology at Work.® www.janam.
XG4 Series Quick Start Guide Copyright 2020 Janam Technologies LLC. All rights reserved. XG4 Series, Janam and the Janam logo are trademarks of Janam Technologies LLC. Other product and brand names may be trademarks or registered trademarks of their respective owners. Janam Technologies LLC assumes no responsibility for any damage or loss resulting from the use of this guide.
Content and Additional Resources To help you get started with your XG4 Series mobile computer, this guide features: - Hardware Overview - Getting Started A. Install the Battery B. Charge the Battery C. Remove the Battery D. Access Card Slot - Battery Warning Contents of this guide are subject to change. For software updates and information, visit www.janam.com.
Hardware Overview Janam Technologies LLC Page 4 1. Front Indicator LED Light (Power, Notification) 2. Scan Indicator LED Light 3. Touch Screen 4. Scan Trigger Keys 5. Keypad 6. Microphone 7. I/O Connector 8.
Hardware Overview Janam Technologies LLC Page 5 1. Scanner & Camera Window 2. Speaker 3. Gun-Trigger Key 4. Gun Handle 5. Li-ion Battery 6. Right Battery Lock 7. Scan Trigger Key 8.
Getting Started Important Note: The main (removable) battery charges the internal backup battery with or without an external power source. Caution: All user data will be lost if the main battery is removed before the internal backup battery is properly charged. It is recommended you check that the backup battery capacity is at 100% prior to removing the main battery. To do this, access Settings-> Battery. It is also recommended that you first suspend the device prior to removing the main battery. A.
Getting Started (continued) C. REMOVE THE BATTERY 1. To remove the battery, press the battery locks of both sides. 2. While pressing the battery locks, grip the side of the battery and pull the battery up. D. ACCESS SD CARD SLOT 1. Remove the battery. 2. Pull the hole of the slot cover to open. 3. Insert a MicroSD card to the slot.
Battery Warning CAUTION IF MISUSED OR MISTREATED THE BATTERY MAY PRESENT A RISK OF FIRE OR CHEMICAL BURN. RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. BATTERY SAFETY GUIDELINES Use only Janam XG4 Series batteries and recharge batteries using only Janam approved charging accessories. Observe the following guidelines for safe use of Li-ion batteries: 1. 2. 3. 4. 5. Do not expose the battery to excessive heat or cold.
Regulatory Body-worn Operation This device was tested for typical bodyworn operations with the Front & back of the device kept 0.59 inches (1.5cm) between the user’s body and the Front & back of the device. To comply with FCC RF exposure requirements, a minimum separation distance of 0.59 inches (1.5cm) must be maintained between the user’s body and the Front & back of the device. Any beltclips, holsters, and similar accessories containing metallic components may not be used.
Regulatory IC Warning This device complies with Industry Canada license-exempt RSS standard(s).Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.