Installation Instructions

JAET2L Accelerometer Sensor
Battery Type: CR2032, 3V
Battery Installation
1. Open plastic case by unscrewing the screw.
2. Install battery with + side facing up. Push battery down so that the 4 clips snap onto the top of the
battery.
3. Close case and tighten screw.
Battery life is 1 to 3 months
Warning:
This product contains a Button or Coin Cell Battery. A swallowed Button or Coin Cell Battery can cause
internal chemical burns leading to death in as little as two hours. Dispose of used batteries immediately.
Keep new and used batteries away from children. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.