Installation & Assembly

ManualsBrandsJACUZZI® ManualsBathNerina Stone Rectangular Vessel Bathroom Sink

SS93000A 1 Installation Instructions

Solid Surface Sink

Installation Instructions

Jacuzzi

is a registered trademark

Questions?

Call our customer service

department at 1-800-288-4002,

9 a.m. - 8 p.m., EST, Monday -

Friday.

Package Contents

Epoxy Mounting Hardware Contents

Bracket

x4 (72x25x2mm)

Base

x4 (Ø6x21x1mm)

Washer

x4 (OD: Ø7mm)

Wing nuts

x4 (Ø6x24x9mm)

AA BB

CC DD

LAVABO BAJO ENCIMERA MIKA

LAVABO ENCASTR

MIKA

MIKAUNDERMOUNTSINK

1-800-288-4002

PRINTED IN CHINA

IMPRIME EN CHINE

IMPRESO EN CHINA

581046

SUGGESTED COUNTERTOP CUTOUT

OVER RIM LIP)

DÉCOUPE DU COMPTOIR SUGGÉRÉE

PAR-DESSUS LE CONTOUR DULAVABO)

CORTE SUGERIDO DE CUBIERTA

PREFABRICADA (PROPORCIONA

SOBRE EL BORDE)

NOTE: BEFORE CUTTING COUNTERTOP

ALLOW FOR FAUCET CLEARANCE

(CHECK HANDLE ON/OFF MOVEMENT)

MUR FINI/DOSSERET

NOTA: ANTES DE CORTAR LA CUBIERTA

PREFABRICADA, DEJE UN ESPACIO PARA

EL GRIFO (VERIFIQUE QUE SE PUEDA ABRIR

Y CERRAR LA MANIJA)

PARED TERMINADA/PROTECTOR CONTRA SALPICADURAS

LÍNEA CENTRAL DE CONEXIÓN

FINISHED WALL/BACK SPLASH

CENTERLINE OF FITTING

1 in. MIN

BOIS

MADERA

VIS À BOIS

TORNILLO PARA MADERA

SINK

LAVABO

FREGADERO

PRODUIT D’ÉTANCHÉITÉ

SELLADOR

WASHER

RONDELLE

ARANDELA

BRACKET

SUPPORT

ABRAZADERA

2,54 cm (1 po) MIN.

1 pulg (2,54 cm) MÍN.

SCR

TORNILLO

BRASS INSERT

GARNITURE EN LAITON

ACCESORIO DE LATÓN

SINK

LAVABO

FREGADERO

WASHER

RONDELLE

ARANDELA

BRACKET

SUPPORT

ABRAZADERA

1 in. MIN

1/2 in.

10mm

MARBRE

MÁRMOL

PRODUIT D’ÉTANCHÉITÉ

SELLADOR

1/2 po

1,27 cm

2,54 cm (1 po) MIN.

1 pulg (2,54 cm) MÍN.

20-5/64 in.

510 mm

2 in.

50.8 mm

2-7/8 in.

EMPLACEMENTS POUR LES CHEVILLES D’ANCRAGE SUR

LE DESSOUS DU COMPTOIR (4 EMPLACEMENTS)

UBICACIÓN DE LASANCLAS DE EXPANSIÓN POR DEBAJO

DE LA CUBIERTA PREFABRICADA (4 UBICACIONES)

ANCHOR LOCATIONS ON UNDERSIDE OF COUNTERTOP

(4 LOCATIONS)

POUR LE MARBRE OU LES SURFACES DURES

PARA SUPERFICIES DE MÁRMOL O SÓLIDAS

POUR LE BOIS

PARA MADERA

VerifyTemplate matches product and item number on box

Vérifiez que le gabarit correspond au produit et au numéro d’article sur la boîte

V erifique que el modelo sea el adecuado para el producto y el número de artículo en la caja

MÉDIANE D’INSTALLATION

REMARQUE : AVANT DE COUPER LE COMPTOIR,

ASSUREZ-VOUS QUE LE DÉGAGEMENT POUR

LE ROBINET EST ADÉQUAT (VÉRIFIEZ LE

MOUVEMENT D’OUVERTURE ET DE FERMETURE

DES POIGNÉES)

Jacuzzi No.:PA46959

Jacuzzi

A1 A2 A3

Undermount Sink Vessel Sink

Sink (x1) Template (x1) Mounting Sink (x1)

Brackets (x4)

Undermount Sink

Vessel Sink

Summary of content (8 pages)

PAGE 1
Solid Surface Sink Installation Instructions Jacuzzi® is a registered trademark of Jacuzzi Inc. ©2017 Jacuzzi Inc. All rights reserved. Questions? Call our customer service department at 1-800-288-4002, 9 a.m. - 8 p.m., EST, Monday Friday. Undermount Sink Vessel Sink Package Contents Undermount Sink Vessel Sink A1 Jacuzzi® is a registered trademark of Jacuzzi Inc. ©2016 Jacuzzi Inc. All rights reserved. Jacuzzi® est une marque de commerce déposée de Jacuzzi Inc. ©Jacuzzi Inc, 2016.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to install, assemble or operate this product. CAUTION Observe local plumbing and building codes. These products are designed for installation in or on countertops with a minimum thickness of 1”. The installer must supply anchors for thinner countertops. Preparation Before attempting to install this product, make sure all parts are present. Compare parts with package and hardware content lists.
PAGE 3
Undermount Installation Instructions (Continued) 6 Epoxy Mounting Brackets To install the sink using the supplied epoxy base brackets, thoroughly clean the underside of the countertop with alcohol in indicated locations as illustrated (Fig. C). Use a thick epoxy (not included) and apply to the bottom through the base holes for maximum contact. Allow the epoxy to properly set prior to installing the sink (A1). Apply adhesive sealant (not included) around the topside rim of sink (A1) near the edge.
PAGE 4
Vessel Installation Instructions (Continued) 4 Check cut-out alignment by temporarily placing the sink (B1) over the desired mounting position as illustrated (Fig. G). 4 Sink Countertop Apply a bead of sealing putty (not included) on the underside of the drain flange in order to ensure a watertight seal between the sink (B1) and the drain. Remove any excess putty after installing the drain onto the sink (B1). Refer to example (Fig. H). Fig.
PAGE 5
Care And Maintenance Recommendations for Gloss Finish 1. 2. 3. For regular cleaning, a universal cleaning agent with nonabrasive properties, or any mild dish soap and warm water solution can be used. After each use, the inner surface must be rinsed with clean water and wiped dry with a clean cotton cloth. Never use abrasive cleaners for any reason. WARNING: Hair dye, “colored” cosmetics (such as mascara, lipstick, face powder etc.
PAGE 6
Limited Warrranty on Jacuzzi® Luxecast® Sinks WARRANTY COVERAGE Jacuzzi Luxury Bath (“Company”) offers a ninety (90) day non-transferrable limited warranty to the original purchaser (“user”) of a Jacuzzi® Luxecast® sink (“Sink”), for personal or single family residential use, subject to the following terms, conditions and limitations. The Company will repair or replace, at its sole option, the Sink in accordance with the terms, conditions and limitations set forth in this limited warranty.
PAGE 7
14525 Monte Vista Avenue Chino, California 91710 Jacuzzi Luxury Bath
PAGE 8
Español WARRANTY REGISTRATION CARD To complete your registration, visit our website at www.jacuzzi.com or fill out and mail this card to the address printed on the other side within thirty (30) days from date of purchase in order for this warranty to be come effective.