Installation Guide

Table Of Contents

Battery installation

1. Pull out JR101 from silicon cover

2. Remove battery cover

3. Put CR2032 battery to battery holder, ”+” mark up

4. Push back battery cover and put JR101 into silicon cover

JR101 Installation Guide

Wear JR101

1. Put Stretchy band trough the rubber hole, put hook same

direction with Logo

2. Tie the JR101 with Stretchy band on ankle

Pairing Device

1. Install Jacfit App and Enable it

2. Shake JR101 to wake it up

3. Choose “Run” to play game

4. Select JR101 Device Series Number to paring

Pairing Device

Move and play game

PAGE 1
JR101 Installation Guide Battery installation Pairing Device 1. Pull out JR101 from silicon cover 1. Install Jacfit App and Enable it 2. Remove battery cover 2. Shake JR101 to wake it up 3. Choose “Run” to play game 3. Put CR2032 battery to battery holder, ”+” mark up 4. Select JR101 Device Series Number to paring 4. Push back battery cover and put JR101 into silicon cover Wear JR101 1. Put Stretchy band trough the rubber hole, put hook same direction with Logo 2.
PAGE 2
FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.