Installation Manual

ManualsBrandsJABIL ManualsElectronicsJSOM CONNECT

JSOM CONNECT MODULE

OEM/Integrators Installation Manual

1. Features

JSOM CONNECT is a highly integrated module with low power single band (2.4GHz) Wireless LAN (WLAN)

and Bluetooth Low Energy communication. The module is limited to OEM installation ONLY, and the OEM

integrator is responsible for ensuring that the end-user has no manual instructions to remove or install

the module that is limited to installation in mobile or fixed application.

802.11 b/g/n 1x1, 2.4GHz

BLE 5.0

Internal 2.4GHz PCB antenna

Size: 40mm x 30mm

USB2.0 Host Interface

Supporting: SPI, UART, I

C, I

S interface application

LCD driver supporting

Audio DAC driver

Supply Power Voltages: 3.135V ~ 3.465V

2. Picture of Product

Top view

Bottom View

Summary of content (8 pages)

PAGE 1
JSOM CONNECT MODULE OEM/Integrators Installation Manual 1. Features JSOM CONNECT is a highly integrated module with low power single band (2.4GHz) Wireless LAN (WLAN) and Bluetooth Low Energy communication. The module is limited to OEM installation ONLY, and the OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install the module that is limited to installation in mobile or fixed application. 802.11 b/g/n 1x1, 2.4GHz BLE 5.0 Internal 2.
PAGE 2
3. Temperature Limit Ratings Parameter Minimum Maximum Unit Storage Temperature -40 +125 C Ambient Operating Temperature -20 +85 C 4. Package Specifications Note: Unit MILIMETERS [MILS] LGA100 Device Dimensions 5. Product general specification Product Specification OPERATING FREQUENCY NUMBER OF CHANNEL CHANNEL OF SPACING RF OUTPUT POWER MODULATION TYPE 802.11 b/g/n: 2412MHz ~ 2472 MHz BLE 5.0: 2402 ~ 2480 MHz 802.11 b/g/n: 1 ~ 13 CH (US, Canada) BLE 5.0: 0 ~ 39 CH 802.
PAGE 3
MODE OF OPERATION BIT RATE OF TRANSMISSION Simplex 802.11 b/g/n: 1/2/5.5/6/9/11/12/18/24/36/48/54 Mbps BLE 5.0: 1/2 Mbps ANTENNA TYPE PCB antenna ANTENNA GAIN 4.97 dBi TEMPERATURE RANGE -20 ~ 85 °C Remark: When using an external antenna with the module, only a PCB/Flex/FPC self-adhesive type antenna can be used, and the maximum gain shall not exceed 4.97dBi.
PAGE 4
6. Application/ Tools A. Image tool B. Wi-Fi UI MP tool UI MP tool could control Wi-Fi radio on test mode for testing purpose.
PAGE 5
PAGE 6
C. BT RF Test tool BT RF test tool could control BLE radio on test mode for testing purpose by following command.
PAGE 7
Regulatory Notices 1. Federal Communications Commission (FCC) Compliance Statement FCC Part 15.19 Statements: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Part 15.
PAGE 8
ISED Canada: This device contains license-exempt transmitter (s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.