User's Manual

ManualsBrandsJ-Three International Holding ManualsElectronicsBluetooth Phone Adaptor

User’s Guide

(Bluetooth Phone Adaptor)

Charger Jack Ear Phone Jack

Reset Pairing

LED

Operating method:

Turn On : Press

【

PAIRING

】

till the LED flash, the n release.

Pairing : Press

【

PAIRING

】

till red/green blinking light, then release. Meanwhile, switch your

Bluetooth headset into pairing mode.

Two devices should connect themselves and green LED flashing shows connected.

LED MODE

REMARKS

RED/GREEN BLINKING PAIRING

GREEN FLASH NORMAL

RED FLASH LOW-BATTERY

RED LIGHT ON RE-CHARGING GREEN INDICATES

BATTERY FULL.

Summary of content (5 pages)

PAGE 1
User’s Guide (Bluetooth Phone Adaptor) Charger Jack Ear Phone J ack Reset Pairing LED Operating method: Turn On : Press 【PAIRING】till the LED flash, the n release. Pairing : Press 【PAIRING】till red/green blinking light, then release. Meanwhile, switch your Bluetooth headset into pairing mode. Two devices should connect themselves and green LED flashing shows connected.
PAGE 2
Bluetooth Headset Volume Adjust Charging Status LED Function key Status LED MIC Operation: ◎ Turning on the headset Switch on the headset by pressing “Function key” max. 3 seconds and a beep tone with LED flashing indicates the headset is on. ◎ Putting HS in Pairing Mode Press and hold the “Function key” for 6 seconds, blinking of red and green LEDs alternately indicates the headset is in Pairing Mode. ＊The default Passkey required for pairing is 0000.
PAGE 3
◎ Disconnecting calls While a call is in session on the headset, press the “Function key” to disconnect the call. After the call is disconnected, the green LED will flash normally. ◎ Putting HS in Standby Mode The headset can be put into Standby Mode in different ways: l Turning on the headset but not going into Pairing Mode l After successfully pairing the headset l Disconnecting from a call Note: The headset can receive incoming calls in Standby Mode.
PAGE 4
J-3 International Holding Co.,LTD Electronic Division FCC Safety Statements The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. The radiated output power is far below the FCC radio frequency exposure limits.
PAGE 5
J-3 International Holding Co.,LTD Electronic Division conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.