Thank you for choosing this special wireless vertical mouse. Please read the user manual carefully when using this product. »>Contents: + Wireless vertical mouse X1 .
» Installation Plug the USB connector for wired mouse (or USB Nona receiver for wireless version) to the USB port in the computer, after detecting successfully it will work normally. > Specification DPI 800/1000/1600, DPI cycle is on the bottom of the mouse Polling rate 125Hz Working Voltage | 1.5V Working Current | < 16mA > Battery Installation 1. Open the battery cover. 2. Put the battery into the mouse in the correct direction. 3. Install the battery cover.
» Receiver Connection 1. Insert the USB Nona receiver to your computer by USB port. 2, After detecting ok by your computer, the mouse can work normally in ON mode. > Building Up the Connection Between Mouse and Receiver If your mouse cannot work normally, you can try to build up the connection again between mouse and receiver, as following steps: 1. Take out the Nona receiver from computer and insert again, it will detect automatically for about 15 seconds. 2.
» Debugging Tips + Check the receiver if is connected to the USB port. + Check the ON/OFF button if in ON mode. + Check the battery if is installed in the correct direction. + Check the batter capacity if is enough. + Check the effective distance between mouse the receiver and shorten it. + Rebuild up the connection between the mouse and receiver. »> Working Environment + The radio signal can penetrate lignin, glass and other non-metallic objects, realizing 360 degree fee transmit.