Installation Instructions

UBC10000PA
FCC Notice:
This device complies with Part 15 of the FCC rules. Operation is subject to the
following twoconditions: 1) this device may not cause harmful interference, and 2)
this device must acceptany interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digitaldevice, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonableprotection against harmful interference in a residential installation.
This equipment generatesuses and can radiate radio frequency energy and, if not
installed and used in accordance withthe instructions, may cause harmful
interference to radio communications. However, there is noguarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning theequipment off and on, the user is encouraged to try to correct the
interference by one or moreof the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver isconnected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance couldvoid the user??s authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.