Instructions / Assembly

Angled Snow Pusher

User Guide

Thank you for purchasing the Ivation® Angled Snow Pusher. This User Guide is intended to provide you with

guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that

does not conform to the guidelines described in this User Guide may void the limited warranty.

Please read all directions before using the product and retain this guide for reference. This product is intended

for household use only.

This product is covered by a limited one-year warranty. Coverage is subject to limits and exclusions. See

warranty for details.

ASSEMBLY

You will need: Allen wrench (supplied), Phillips head screwdriver, wrench.

PARTS LIST:

TO ASSEMBLE

1. Attach the two sides of the blade:

Position the blades (A) so that they form a

right angle.

Locate the hole on the back of the joined blade,

a few inches down from where the two blades

meet at the top.

Press one black plastic tube (U) into each end of

the hole, top and bottom, with the notched side

of the tube facing down. Press down to secure.

Using long screw (F) and washer (W) and bolt (Q), push the screw through the hole, secure with the

washer and bolt, and tighten with a screwdriver.

RS T UVW X

HIJKL MN O P Q

BCDE F

PAGE 1
Angled Snow Pusher User Guide Thank you for purchasing the Ivation® Angled Snow Pusher. This User Guide is intended to provide you with guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the guidelines described in this User Guide may void the limited warranty. Please read all directions before using the product and retain this guide for reference. This product is intended for household use only.
PAGE 2
Locate the two metal cuffs (P). Slide a cuff over the middle section of the top of the right angle so that it covers the seams. Do this on both sides (top and bottom) of the angled blade. Slide the Allen bolt (H) through the hole on the side of the cuff. Place lock nut (Q) on the open end of the bolt. Note: The wells on the blade, on each side of the cuff, are designed to accommodate the Allen bolt and lock nut in only one way. Tighten the bolt with the Allen wrench (X).
PAGE 3
4. Attach Handle: Position blade so that the wheels touch the floor. Locate the notches on the top of each arm. Attach the metal, U-shaped bar (B), aligning holes to the holes in the arms, with screws (G) and bolts (R). Attach upper part of handle using screws (O) and bolts (K). You can increase or decrease the total length of the handle according to your preference. The sets of holes on the sides of the handle give you three height options. This product is covered by a limited one-year warranty.