Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
Important! You must twist—not wrap—the cable armor onto the Cellular 500W
cable. Wrapping the cable armor can cause the stainless steel jacket to warp.
You must begin twisting the cable armorover the portion of the cable protected
by the electrical tape. If you do twist the cable armor onto the Cellular 500W
cable on the unprotected portion of the Cellular 500W cable, you could damage
the module's cable. A cut cable could cause a Cellular 500W or register
communication failure.
5. Continue to twist the cable armor onto the Cellular 500W cable until the cable armor
covers the entire cable.
6. Remove any leftover materials from the customer premises. Discard or recycle leftover
materials.
To install the cable armor
1. Remove the installed Cellular 500W.
Note: Itron strongly recommends that you keep the Cellular 500W connected to the
register during cable armor installation.
2. Cut a two to three inch strip of electrical tape.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 36 of 44
DRAFT