Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
Warning! Use Itron mounting screws (SCR-0010-005). Using the wrong
mounting screws could crack the plastic module housing.
7. If you have not already done so, connect the register to the water meter and fully tighten
the mounting screw (1) as directed by Badger Meter instructions.
Note: Mount the register on the meter in one of four different positions with respect to
the direction of water flow (refer to the manufacturer's installation directions).
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 28 of 44
DRAFT