Installation Guide
Table Of Contents
- Cellular 500W Remote Module Installation Guide
- Contents
- New in This Document
- 1 Introduction
- 2 Initialization, Connection, and Programming
- 3 Setup and Installation
- 4 Completing Gel-cap Connections Using the Itron Splice Tube Kit
- 5 Troubleshooting
- 6 Important Safety and Compliance Information
3. Align the remote module backplate with the mounting screw holes. Verify that the Itron
logo is not upside down.
4. Insert a backplate mounting screw in one corner and tighten the screw two or three turns.
Insert the remaining three screws and tighten each a few turns.
Cellular 500W Remote Module Installation Guide 3 Setup and Installation
October 11, 2021 815-0618-00 REV 000 Itron, Inc. Page 21 of 44
DRAFT