Our Focus , Your Legend 802.11 b/g/n single chip Storage Temperature -40℃~125℃ Antenna external Operation System windows XP32/64,Vista 32/64, Win7 32/64, Linux, Mac Operation Voltage 3.3V DC 6. Size Of Module Graph 6.1 Physical Map 8 Iton Technology Corp www.sziton.
802.11 b/g/n single chip Our Focus , Your Legend 6.2 Machine Size Map And Pin Definition Pin Definition Pin Name Description 1 VCC 3.3V 2 DP USB D+ signal 3 DM USB D- signal 4 GND Ground 5 NC No connect 7.Process Parameters TBD 9 Iton Technology Corp www.sziton.
802.11 b/g/n single chip Our Focus , Your Legend 8.Packaging Information Packing information :blister + vacuum bag The module into the blister case The blister packed module and desiccant into the vacuum bag Blister (5*10) A good vacuum sealed vacuum bag in turn into cartons Vacuum bag Cartons 10 Iton Technology Corp www.sziton.
9.Application Installation Guide Finished Assembly Master PCB (examples) 1. Check MW1601‐5P Module connection pin is clean for soldering. 2. Ready the Master PCB which will connect with MW1601-5P Module. Check connection pads is clean forsoldering.Place the Module on the Master PCB with SMT.
3. After soldering,Check all pads are well connected. 4. Connect DC Power 3.3V on VCC and GND on Master PCB.Connect to Antenna by antenna connector. Antenna connector NOTE:The antenna gain should no more than 0 dBi.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Attention: Limited Modular Approval ‐ this RF Module may not be sold to the generic public and requires professional installation. Due to the fact that this RF Module is not equipped with an own shielding, the end‐product incl. this RF Module has to show compliance to the FCC rules (15C / radiated emissions). (OEM) Integrator has to assure compliance of the entire end‐product incl. the integrated RF Module. Additional measurements (15C) and/or equipment authorizations (e.
