Installation Instructions

DC 5V=1.0A, 5V=1.5A, 9V=1.2A

FCC Part 15 Compliance

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may

not cause harmful interference, and (2) this device must accept

any interference received, including interference that may

cause undesired operation.

CAUTION: Changes or modifications not expressly approved

by the party responsible for compliance could void the user’s

authority to operate the product.

Note: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician

for help.

This equipment complies with FCC radiation exposure limits

set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance 20cm

between the radiator and your body. This transmitter must not

be co-located or operating in conjunction with any other antenna

or transmitter.

PAGE 1
FCC Part 15 Compliance DC 5V=1.0A, 5V=1.5A, 9V=1.2A This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.
PAGE 2
This wireless charger is applicable to all ACRISS Car Classification Category. When installed properly per instructions, distance between you and the Wireless Charging are as below: 1)When sitting on the driver seat steering car, at least 50cm, 72cm, 83cm, 90cm to Knee, Leg, Body, Head respectively. 2)When Sitting on the front passenger seat, at least 32cm, 43cm,63cm, 55cm to Knee, Leg, Body, Head respectively.