2450MHzDigital Wireless Microphone System USER GUIDE
TABLE OF CONTENTS 1. Description of the units ....................................... ........................3 1. Quick Set Up and Operation .......................................................4 2. Installation....................................................................................5 3. Guidelines For Best Performance................................................6 4. Troubleshooting Guide.................................................................7 5. Technical Specifications..........
FCC NOTICE THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDERSIRED OPERATION. < Part 15.106> This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
DESCRIPTION Base (Receiver) Antenna Connection Audio Jack Input Terminal For charging Modular Jack Green LED: In-use, Record RED LED: Charging Green LED: Full charge Transmitter Green: In-use (Light On) Record (Flashing) RED LED: Out of Range RED LED: Low Battery Record Button Emergency Button Lapel Mic.
1. QUICK SET UP AND OPERATION Synching Up the Transmitter and Base The synch operation only needs to be performed the first time a system is used, or a new bodypack is used with a base previously synched to another bodypack. Do not perform the synch operation multiple times; it only needs to be done one time when a new bodypack is used with a new base. 1) 2) 3) 4) 5) Turn the transmitter power switch to ON and place the transmitter in the recharge cradle of the base.
2) A +12V signal on the line means the microphone is Record off. 3) 0V or ground on the line turns on the microphone is Record on. 2. INSTALLATION PIN DESCRIPTION OF THE BASE OUTPUT PORT Connector wire (RJ45) Pin #1 : Transmitter Audio out Pin #2 : In Car Mic. Audio out Pin #3 : 12V DC_IN Pin #4 : Ground Pin #5 : Record Trigger OUT Pin #6 : Record Trigger IN Pin #7 : Panic Trigger Out Pin #8 : In Car Mic.
LED will light if there is power. If the LEDs do not come on, check the connections and repeat. Type B Wire the un-terminated signal wires to the control unit according to the signal chart. A 5 Amp fast blow fuse is recommend in the 12VDC power supply line to protect the equipment. Pin #1 : Transmitter Audio out Pin #2 : In Car Mic. Audio out Pin #3 : 12V DC_IN Pin #4 : Ground Pin #5 : Record Trigger Out Pin #6 : Record Trigger IN Pin #7 : Panic Trigger Out Pin #8 : In Car Mic.
base previously synched to another bodypack. Do not synch multiple times, just once until a new bodypack is used. Any Base can be synchronized with any Transmitter. Using Multiple Wireless Systems The WPM2430 system has 100 possible “channels” that are really different frequency hopping schemes. Potential Sources of Interference There are many potential sources of interference for your wireless system.
5. TECHNICAL SPECIFICATIONS RECEIVER BASE STATION Controls Video Trigger Active +12/GND Indicators INUSE LED: CHARGE LED : GREEN CHARGING -> RED FULL CHARGED -> GREEN RECORD LED Connections GREEN FLASHING In Car Mic. Un-terminated Cord RED BLUE YELLOW ORANGE BLACK GRAY Audio Connector Tip Ring Sleeve 2.
6. FACTORY SERVICE ( NORTH AMERICA ) If factory service is required, ship the unit prepaid in its original carton to: Enclose a note describing the problem along with any other pertinent information and how to contact you 7.
