Owner manual

CONNECTION CONFIGURATIONS
GUITAR
Congratulations on the purchase of the Fetish pedal. The
Fetish has some unique features that create a versatile
distortion device depending on the settings.
The Fetish utilizes Field Effect Transistors to create a
dynamic and soft clipping gain boost effect prior to the
distortion circuit. Moreover, with the added gain structure
the pedal has more gain than typical overdrives. Also for
tone shaping, the distortion circuit uses a 4558 IC. With the
gain structure utilized, the Fetish can be used as a clean
boost and or a treble boost. In addition, to create depth to
the overall sound, a Fat control is featured to boost low end.
.
9V DC ADAPTER
LED- WHEN ON
EFFECT IS ENGAGED
OUTPUT INPUT
ACTIVE/BYPASS
SWITCH
THUMBSCREW
BATTERY ACCESS
GAIN – Sets the amount of distortion desired. With
the gain set to minimum, the distortion circuit
is set to unity gain allowing for clean boost
settings via the output control.
OUTPUT– Adjusts the overall level.
TONE – Adjusts the amount of treble after the distortion
circuit.
FAT – Adjusts the amount of bass to the overall
circuit.
BATTERY/ADAPTER
To install the battery, loosen the thumbscrew shown above
and raise the switch cover to allow access to the battery
compartment. Insert a 9v battery to the connector, place
the battery into its compartment, and close by holding the
switch cover down and tightening the thumbscrew.
To use the Fetish with an external power adapter, select an
adapter with at least 100 milliamps capability at 9 volts DC.
Make sure the adapter is polarized “TIP NEGATIVE.”
WARRANTY & SERVICE
This unit parts and workmanship are fully guaranteed
to be free of defects under normal use and service for
a period of three years from date of purchase. Any
damage resulting from misuse of the failure to follow
the precautions and instructions will void the warranty.
In the event that the unit needs to be repaired, please
return the unit to ISP Technologies directly. Simply
re-pack the unit, send a copy of your original receipt,
a note stating the problem and send it to:
ISP Technologies
5479 Perry Dr. Suite B
Waterford, Mich.48329
ATTEN: Repair Dept.
All shipping charges must be prepaid.
ISP will not be responsible for any damages incurred
in the shipping of any unit. Any claim will need to be
settled with the shipping company. The warranty will
be voided if the serial number has been tampered with.
Should you have any questions for the repair dept prior
to returning the product please call:
PHONE [phone]
FAX [phone]
www.isptechnologies.com