PRC-001 Clear Net Proximity Reader Controller INSTALLATION AND OPERATION MANUAL ONASSIS "..The integrated solution for access control...
Clear Net Proximity Reader Controller PRC-001 Installation Manual The purpose of this manual is to provide the information required to install, operate and maintain the Clear Net proximity reader controller, PRC-001, from ONASSIS. This manual is intended for those individuals (end user or dealer) who will be installing, configuring and placing the Clear Net proximity reader controller, PRC001, in operation at a given installation site.
The proximity reader controller, PRC-001, consists of a rectangular sealed, all weather housing that can easily fit on a door mullion or in any location near a door. The dark charcoal-blue housing is made of a UV stabilized poly carbonate blended material that is both durable and resistant to weather. Mounting holes are located exactly six (6) inches apart on the center line of the short dimension of the housing.
Some care should be taken when choosing a location to install the Clear Net proximity reader controller. The failure to locate the reader away from any radio frequency interference sources could cause reduced performance in read range and read speed. Do not locate the PRC-001 near broad spectrum EMI noises such as those generated by motors, pumps, generators, DC-AC converters, AC switching relays, light dimmers and CRTs.
LAY TO MAGNETIC LOCK POWER SUPPLY TTL 2 OUTPUT TIL 1 OUTPUT RS-485 DATA LINES DOOR STRIKE OPTIONAL REQUEST TO EXIT AUXILIARY INPUT Figure 2 Clear Net Proximity Reader Controller PRC-001 Connection Diagram When powering up the reader, the reader will go through a diagnostic routine that takes about 10 15 seconds. The reader will initiate an audible tone within the first 5 to 10 seconds and the top red LED will turn on.
First Method In the first method, the installer can provide programmed cards for the three options of “adding”, “deleting”, and “locking “ out cardholders. Once you possess the three master cards, you can add and delete cardholders by using either card to put the reader in a state of being programmed. The lock card is used to lock down the door during off hours. When you use any of these three cards, the bottom LED will light up amber.
IF all the connections on the reader are correct, and power is evident by the indication of the top LED being red, and there is a non-functioning feature, call ONASSIS at either 303-440-5155 or 949-713-2742 and ask for field service. The PRC-001 “Clear Net” Proximity Reader Controller is a new type of access control reader product.
It is very important to terminate all R-485 connections with a 120 ohm termination resistor identified in the figure above when using a daisy chain wiring configuration. When connecting to the PC, you will need to use an RS-485 to RS232 converter plug. Other wiring configurations using off-the-shelf RS-485 hubs and repeaters will work seamlessly with the PRC-001 readers. » LY The integrated solution for access control...