Installation Manual

User Guidance for the Sundial Module model: AXF-Y1
FCC ID: UFE-AXFY1
IC: 6652A-AXFY1
1. Introduction
Module Name: Sundial
Module Model Number: AXF-Y1
The Sundial module model AXF-Y1 is a 2.4GHz Wi-Fi module which is compliant with IEEE
802.11b/g/n specifications.
2. Electrical
Chipset: The Sundial module main chipset: MediaTek MT7688
Supply: The module source all require power from 5VDC input supply
3. Environmental
Operating Temperature: The Sundial module operates across the temperate range of -10° to
55° Celsius
4. OEM/Integrators Installation Manual:
Important Notice to OEM Integrators
1. This module is limited to iRobot Corporation use ONLY.
2. Any modifications to the Sundial module model AXF-Y1 may invalidate regulatory
approvals or may necessitate notifications to the relevant regulatory authorities.
3. OEM must inform iRobot Compliance of any changes which may require the Class I
or Class II permissive changes for the FCC.
4. The Sundial Radio module model AXF-Y1 uses an internal PCB trace antenna. Any
substituted antenna and RF cable assemblies must be tested and approved in order
to maintain compliance to FCC and ISED rules.
5. For FCC Part 15.31(h) and (k): The host manufacturer is responsible for additional
testing to verify compliance as a composite system. When testing the host device
for compliance with Part 15 Subpart B, the host manufacturer is required to show
compliance with Part 15 Subpart B while the transmitter module(s) are installed and
operating. The module should be transmitting and the evaluation should confirm
that the module’s intentional emissions are compliant with the transmitter rules.