Installation Manual

User Guidance for Module AXD-Y1
FCC ID: UFEAXD-Y1; IC: 6652A-AXDY1
1. Introduction
Module Model Name: AXD-Y1
This module AXD-Y1 is the dual-band 2.4GHz and 5GHz bands Wi-Fi module which is
compliant with IEEE802.11a/b/g/n/ac specification.
Bluetooth (BT) compliant with the BT specification version 4.2 (BLE).
2. Electrical
Chipset: The module main chipset: APQ8009, PM8916, QCA6174A
Supply: The module source all required power from a 4.3V +/- 0.3V input supply.
3. Environmental
Operating Temperature: The module operate across the temperature range of -10°to
55°Celsius
4. OEM/Integrators Installation Manual:
 Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to
Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and different antenna
configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional
testing to verify compliance as a composite system. When testing the host device for
compliance with Part 15 Subpart B, the host manufacturer is required to show
compliance with Part 15 Subpart B while the transmitter module(s) are installed and
operating. The modules should be transmitting and the evaluation should confirm
that the module's intentional emissions are compliant (i.e. fundamental and out of
band emissions). The host manufacturer must verify that there are no additional
unintentional emissions other than what is permitted in Part 15 Subpart B or
emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B
requirements if needed.
 End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible
through a window on the final device or it must be visible when an access panel,