43755_user_guide 2/1/05 5:00 PM Page 1 9522A L-BAND TRANSCEIVER USER’S GUIDE
43755_user_guide 2/1/05 5:00 PM Page 2 Contents Export Compliance Information . . . . 1 1 Product Overview . . . . . . . . . . . . . 1 2 Standards Compliance . . . . . . . . . 1 2.1 FCC Compliance . . . . . . . . . . . 1 2.2 CE Compliace . . . . . . . . . . . . . 1 3 Physical Specifications . . . . . . . . . 2 3.1 Environmental . . . . . . . . . . . . . 2 3.2 Dimensions . . . . . . . . . . . . . . . 2 3.3 Interface Connectors . . . . . . . 3 3.3.1 Multi-Interface Connector . . 3 3.3.
43755_user_guide 2/1/05 5:00 PM Page 3 4.3.1 RS232 Data Signal Descriptions . . . . . . . . . . . . . 6 4.3.2 Autobaud . . . . . . . . . . . . . . . 6 4.4 Analog Audio Interface . . . . . . 6 4.4.1 Analog Audio Interface Signal Descriptions.. . . . . . . . . . . . . 6 4.5 SIM Interface . . . . . . . . . . . . . . 6 4.6 RF Interface . . . . . . . . . . . . . . . 7 4.6.1 RF Interface Specifications . 7 4.6.2 Radio Characteristics . . . . . 7 5 Instructions for Safe Installation . . . 7 5.
3755_user_guide 2/1/05 5:00 PM Page 4 Export Compliance Information This product is controlled by the export laws and regulations of the United States of America. The U.S. Governement may restrict the export or re-export of this product to certain individuals and/or destinations. For further information, contact the U.S. Department of Commerce, Bureau of Industry and Security or visit www.bis.doc.gov.
43755_user_guide 2/1/05 5:00 PM Page 5 3 Physical Specifications The 9522A LBT is depicted in Figure 1 below. Figure 1: Top View 3.1 Environmental The environmental specifications of the 9522A LBT are summarized in Table 1 below. Table 1: Environmental Specifications Parameter Value Operating Temperature Range -10ºC to + 55ºC Operating Humidity Range ≤ Storage Temperature Range -40ºC to + 85ºC Storage Humidity Range ≤ 75% RH 93% RH 3.
43755_user_guide 2/1/05 5:00 PM Page 6 Figure 3: Bottom View Figure 4: Antenna Connector End View Figure 5: Multi-Interface Connector End View 3.3 Interface Connectors The 9522A LBT incorporates three interface connectors. • Multi-Interface Connector (located on the end of the 9522A LBT) • Antenna Connector (located on the end of the 9522A LBT; opposite to the multi-interface connector) • Subscriber Identity Module (SIM) Chip Connector (located beneath a cover plate atop the 9522A LBT) 3.3.
43755_user_guide 2/1/05 5:00 PM Page 7 Table 3: 25-way connector pin-out Contact Signal Description 1 EXT_ON_OFF External connection for On / Off key input to Daytona LBT 2 EXT_11HZ 90ms “frame sync” signal (used in testing) 3 EXT_GND Power Ground input to Daytona LBT 4 EXT_PWR Power input to Daytona LBT 5 SPKR_AUD Speaker audio output from Daytona LBT 6 DA_TX PCM digital audio output from Daytona LBT 7 DF_RI Data / Fax Ring Indication output from Daytona LBT 8 DF_RTS Data / Fa
43755_user_guide 2/1/05 5:00 PM Page 8 P8124-00, 3BE-P817-00, and 3BE-P818-00 respectively. A 10IP Torx Plus® flat head version is also available in a single length of 1/2 inch as part number 3BE-P801-00. Another 6-32 thread type option is to insert a helical coil insert with a 6-32 internal thread into these features thus accommodating 6-32 threaded fasteners as mounting hardware for the 9522A LBT.
43755_user_guide 2/1/05 5:00 PM Page 9 Table 5: DC Power Input Specifications Parameter Value Main Input Voltage - Range +4.0 VDC to +4.8 VDC Main Input Voltage – Nominal 4.4VDC Main Input Voltage – Ripple 40 mVpp Peak Input Current (maximum) 2.5 A @ 4.4 VDC Main Input Active Power (average) 2000 mW Main Input Standby Power (average) 550 mW 4.2 Control/Digital Audio (DPL bus) Interface 4.2.
43755_user_guide 2/1/05 5:00 PM Page 10 4.6 RF Interface 4.6.1 RF Interface Specifications The RF interface requirements for the 9522A LBT are summarized in Table 7 below. Table 7: General RF Parameters Parameter Value Frequency Range 1616 MHz to 1626.5 MHz Duplexing Method TDD (Time Domain Duplex) Oscillator Stability ± 1.5 ppm Input/Output Impedance 50Ω Multiplexing Method TDMA/FDMA 4.6.2 Radio Characteristics The tables within this section contain radio characteristics of the 9522A LBT.
43755_user_guide 2/1/05 5:00 PM Page 11 The current and voltage rating of the multi-interface connector cable shall meet the requirements of the LBT DC power input. The electrical characteristics of the multi-interface connector cable shall not degrade the 9522A LBT digital communications and analog audio signals. The multi-interface connector cable will provide adequate screening from external electromagnetic interference.
43755_user_guide 2/1/05 5:00 PM Page 12 Iridium Limited Warranty For Satellite Subscriber Radiotelephone Products 1.
43755_user_guide 2/1/05 5:00 PM Page 13 ed for batteries if: a) such batteries are charged by other than the Iridium-approved battery charger specified for charging such batteries; b) any seals on such batteries are broken or show evidence of tampering; or c) such batteries are used in equipment other than the Product for which they are specified; or d) such batteries are charged and stored at temperatures greater than 60 degrees centigrade. g.
43755_user_guide 2/1/05 5:00 PM Page 14 with emergency 911or emergency 112 or any other distress calling or emergency services, both public of privately operated, acknowledge and agree as a condition of the provision of phone service and equipment by Iridium that they will make no claim, whether in contract, tort or otherwise, against Iridium for bodily injury, loss of life, damage to property or for any other loss whatsoever, or for special, incidental, indirect, consequential or punitive damages, by r
43755_user_guide 2/1/05 5:00 PM Page 15 E C Directive Declaration of Conformity This is to certify that the following equipment complies with all relevant Essential Health and Safety Requirements of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EC and the Low Voltage Directive 73/23/EC as amended by 93/68/EC.
43755_user_guide 2/1/05 5:00 PM Page 16 Iridium Satellite LLC Headquarters 6701 Democracy Blvd., Suite 500 Bethesda, MD 20817 USA Phone +1.301.571.6200 Fax +1.301.571.6250 Iridium Satellite LLC 8440 S. River Parkway Tempe, AZ 85284 Toll Free +1.866.947.4348 Local or International +1.480.752.5155 Fax +1.480.752.1105 email info@iridium.com www.iridium.