User Manual

DUOGUARD
PIR + Microwave Motion Detector
DP-250
Installation Instructions
R
INTERNAL VIEW
ALARM TAMPER
SW4
C17
C28
BY1
C31
C4
C33
C32
LED2
LED3
LED1
1/3
MAX.
2/3
MW.RANGE
C10 C12 C8
ALM
MW
PIR
SWB
SWA
CT35
Terminals
Microwave sensor
PIR LED
(Yellow)
Microwave range
adjustment
Tamper switch
Relay
Alarm LED
(Red)
Infrared sensor
(Don't touch!)
Microwave LEC
(Green)
Jumper switch
Locking bolt
Cable access
INSTALLATION HINTS
The DUOGUARD may be either wall or corner
mounted by applying different knockouts. The MB-95
or MB-99 mounting bracket can be applied for ceiling
or wall mount. Corner mount is generally
recommended for optimum detection.
Do not install where the detector
is in or facing direct/reflected
sunlight, windows onto main
roads (car head lights) or strong
draughts / heaters.
Ensure that there are not any
obstructions (plants, screens,
furniture etc.) in the field of view
which may cause incorrect cover/
operation of the detector.
Avoid locating the detector in
areas which contain equipment
that may change the environment
temperature rapidly.
Locate the detector at least 1
meter away from any illumination
to avoid possible interference to
microwave sensor.
)
Avoid running alarm wiring close to mains cables !!!
DETECTION PATTERN
Model:
DP-250
110
°
, 15 x 15m at 25
°
C Top View
Side View
INSTALLATION & WIRING
Installation
1. Open the front cover by loosening the locking
bolt at the bottom of the case.
2. Remove the printed circuit board from the base of
the unit, by bending the P.C.B clips gently
upwards (handle printed circuit board with care).
3. Punch out the required knockouts and mount the
unit base to the wall, corner or bracket.
4. Lead the cable through the access hole and then
refit the printed circuit board.
5. Connect the wires to the respective terminals
according to the wiring instructions.
6. Replace the front cover after completing the
wiring and carry out a through walk test.
Wiring
+
ALARM
TAMPER
-
Tamper output (N.C loop)
Alarm output (N.C loop)
Power input (9 ~ 16 VDC)
Min. 1m
Light
)
TAMPER terminals should be connected to the 24
hours N.C supervised loop of control panel.