User's Manual

ManualsBrandsIR-TEC International ManualsElectronics360 Degree Ceiling Mount Dual-Tech Motion Detector

360° Ceiling Mount PIR+MW Dual-Tech Motion Detector

DP-363

Installation Instructions

GENERAL

Thank you for choosing IR-TEC dual technology

motion detector for your security system. The DP-363

is a 360° ceiling mount motion detector that combines

a passive infrared (PIR) and a DRO microwave (MW)

motion sensor in a sleek housing. It utilizes AND logic

discretion and advanced signal processing to provide

superior intrusion detection reliability. To achieve the

best detection, please read all instructions thoroughly

prior to installation.

INSTALLATION HINTS

1. The DP-363 should be mounted on a firm section

of ceiling and located for optimum coverage.

2. Do not install where the detector is exposed to

direct or mirror-reflected sunlight.

3. Make sure the detection area does not have

obstruction which may block the detection zones.

4. Avoid running the alarm cable along with AC

mains cable to prevent EMI.

5. Locate the detector at least 0.3 m (1ft) away from

fluorescent light to avoid possible interference to

the microwave sensor.

INTERNAL

VIEW/INSTALLATION

Internal View

Installation Illustration

PCB Disassembly Diagram

Description

1. Loosen the cover locking screw, open the cover.

2. Refer to the PCB disassembly diagram, carefully

remove the PC board from the bottom base.

3. Knockout the adequate cable access and mounting

holes on the bottom base.

4. Lead the alarm cable through the access hole, and

mount the bottom base at the selected location.

5. Replace the PCB at the bottom case. Connect the

signal wires with the terminals according to the

wiring diagram as below.

6. Replace the front cover and then walk test can be

conducted.

Wiring Diagram

Warning: TAMPER output should connect with the

24- hour N.C supervised loop of control panel.

DETECTION PATTERN

Summary of content (3 pages)

PAGE 1
R 360° Ceiling Mount PIR+MW Dual-Tech Motion Detector DP-363 GENERAL Installation Instructions PCB Disassembly Diagram Thank you for choosing IR-TEC dual technology motion detector for your security system. The DP-363 is a 360° ceiling mount motion detector that combines a passive infrared (PIR) and a DRO microwave (MW) motion sensor in a sleek housing. It utilizes AND logic discretion and advanced signal processing to provide superior intrusion detection reliability.
PAGE 2
WALK TEST & ADJUSTMENT FUNCTION SETTING SW1 DIP switch is available for all function settings of the detector. Please refer to the following instructions for setting options. l l The black blocks indicate switch position. The left shows factory default setting.
PAGE 3
Note: 1.Any changes of modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. 2.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.