To charge the M5™ Main Battery: 1. Remove the Non-rechargeable Backup Battery door from the SSPM, and disconnect and remove the Non-rechargeable Backup Battery. 2. Plug the charging cable into an AC power supply.
Caution: At the JMP6 header on the main board, ensure the jumper (JMP0002) is properly connected. 3. Plug a male connector from the charging cable into the female connector of the SSPM (on the bottom of the SSPM).
4. On the SSPM, quickly insert and remove a Diagnostics card from the EMV card reader to enter Diagnostics mode. 5. Press + Time (more time) / — Time (less time) to scroll to Voltages, and ensure the meter enters “Charging” mode indicated by ^ on the display.
6. Continue charging the battery ≥ 4 hours. Caution: Do not leave the battery charging unattended / overnight. All battery-charging activities carry inherent risk and must be supervised at all times. 7. In ≥ 4 hours, disconnect the meter from the charging cable. 8. Re-connect and replace the Non-rechargeable Backup Battery, and battery door. 9. Check the battery voltages to ensure Non-rechargeable Backup Battery and the Rechargeable Main Battery both measure > 3100 mV.
How To Replace an SSMP Backup Battery This task topic discusses how to replace the IPS Group, Inc. SSPM backup battery. The Backup Battery life of the SSPM is among the best in the industry. The battery is easily serviced in the field, requiring no tools to remove. To replace the SSPM Backup Battery: 1. Remove the meter mechanism from the meter base housing. 2. Remove the battery compartment door from the left side of the meter mechanism. 3.
5. 6. 7. 8. 9. 10. Quickly insert and remove a Diagnostics card from the card reader to enter Diagnostics mode. Press √ OK > X Cancel to enter Diagnostics mode - level 2. Press + Time (more time) / — Time (less time) to select COMMS Test. Press √ OK to enter the COMMS Test menu, to set the meter to the current time. Press + Time (more time) / — Time (less time) to select Replace Bat. Press √ OK to enter Replace, then press — Time (less time) to confirm the battery replacement.
4. Once the communication test is complete, and the LCD shows GSM Close, press X Cancel repeatedly until the meter returns to normal operating mode.
Glossary D DMS Data Management System E EMV Europay, MasterCard, and Visa F FCC Federal Communications Commission G GPRS General Packet Radio Services GSM Global System for Mobile Communications 85
L LCD Liquid Crystal Display LED Light Emmiting Diode Li-SOCI2 Lithium-Thionyl Chloride N NFC Near Field Communication P PCBA Printed Circuit Board Assembly R RFID Radio Frequency Identification 86
S SIM Subscriber Identification Module SSPM Single-Space Parking Meter 87
Index A Access Cards 41 Collection 42 Diagnostics 41 Maintenance 43 After Hours 52 Antenna NFC 38 B Battery 29, 35, 77 Backup 29 Main 29, 77 Battery Cover 35 C Card Entry Slot 34 Card Operation 67 88
Card Reader 36, 38 Card Reader Sub-Assembly 36 Card Slot 45 Card Test 24 Cards 16, 41 Chassis 36-37 Chassis Plate 37 Cleaning Display 61 General 60 Coin 66 Coin Decal 34 Coin Entry Slot 34 Coin Entry Slot Plate 36 Coin Operation 66 Coin Slot 46 Coin Test 24 Coin Validator 34 Coins 17 Comms Test 25 89
Contact us 9 D Decal 53 Diagnostics 47 Button 34, 47 Card 41 Mode 20 Level 1 20 Level 2 21 Level 3 22 Sub-menus 23 Display 34, 48, 61 PCBA 38 Display PCBA 36 E Error messages 57 Expired 13, 52 Expiry Indicator 37 90
F Fault 16 Fault codes 58 Fault Logging 26 Faults 23 FCC 10 Functions 36 G GPRS 25 GSM 25 H Head Lens 40-41 Head Upper Casting 39-40 I Idle 13, 52 Interface Gasket 40-41 Issues 58 Coin 59 91
Communication 59 Power 58 J jumper 77, 79 Jumper 29, 64 K Keypad 34, 50 L LCD 38 LCD Spacer 38 LED 51 LEDs 34 M Main Battery 77 Main PCBA 36-37 Maintenance 60 Meter Swap 27 92
Module Case Front 36 Rear 36 N NFC 35 Antenna 36, 38 Bezel 36 No Parking 52 No Payment 19 O Off 65 On 63 Out Of Order 18, 53 P Paid 15, 53 Parts 35 PCBA Chassis 36 Prepay 19 93
R Rear Expiry LEDs 36 RFID 43 Reader 44 Tag 43 S Sleep 29 Solar Assembly 36 Gasket 39, 41 Panel 29, 34, 37, 55 PCBA 37 T Top Covers 39 Model 132 40 Model 147 40 Model 795 39 Trademarks 10 Troubleshooting 58 94
Tun On 63 Turn Off 65 V Validator 36, 56 Validator Connector 36 Voltage 28-29 95