User's Manual

There are three standard methods of attaching our tracking tags to an Asset.

1. Stick - 3M tape

2. Keyring

3. Rivet / Screw

Simply pick your preferred attachment method above and attach each tag to

its corresponding asset.

Tags are delivered turned off. Hold button for 3 seconds to turn on. It will play

a short sound and flash Blue LED three times.

You can press the button to make sure that the tag is turned on - Tag will flash

a red / blue LED after a short press if turned on. When turned off there is a

smaller green flash.

Notes:

- The rubber pieces filling the key ring holes on our Vector Tags can be

removed by using a tool to lever them out.

- Tag orientation can be important for signal propagation

- Remember that the Tags have a replaceable battery, so make sure the battery

can be accessed

Vector User manual

PAGE 1
Vector User manual There are three standard methods of attaching our tracking tags to an Asset. 1. Stick - 3M tape 2. Keyring 3. Rivet / Screw Simply pick your preferred attachment method above and attach each tag to its corresponding asset. Tags are delivered turned off. Hold button for 3 seconds to turn on. It will play a short sound and flash Blue LED three times. You can press the button to make sure that the tag is turned on - Tag will flash a red / blue LED after a short press if turned on.
PAGE 2
FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.