Installation Instructions

ITS-GW01

Quick Startup Guide

Step 1: Connect the Hardware

i. Connect the power adapter to the system (5V@3A5.5/2.1mm DC) and plug the system in.

ii. Connect to a display by plugging a VGA connector into the port on the system. Ensure the other end of

the VGA cable is plugged into the display properly.

iii. Connect your keyboard and mouse to the system.

(Note: Ensure everything is connected properly and securely.)

Step 2: Prepare Drive

i. Prepare the bootable drive with the OS (Linux).

Step 3: Turn On

i. Turn on the system power and install the OS and drivers.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Caution:

To assure continued FCC compliance:

1. Any changes or modifications not expressly approved by the grantee of this device could void the user's

authority to operate the equipment.

2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

PAGE 1
ITS-GW01 Quick Startup Guide Step 1: Connect the Hardware i. Connect the power adapter to the system (5V@3A5.5/2.1mm DC) and plug the system in. ii. Connect to a display by plugging a VGA connector into the port on the system. Ensure the other end of the VGA cable is plugged into the display properly. iii. Connect your keyboard and mouse to the system. (Note: Ensure everything is connected properly and securely.) Step 2: Prepare Drive i. Prepare the bootable drive with the OS (Linux). Step 3: Turn On i.
PAGE 2
Regulatory Information This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.